Separate names with a comma.
Hi Jason, Maybe a stupid question, but there is a 20A fuse on +(red) wire going from the converter to OEM NiMh battery located inside black...
Yes, but Prius+ Li-Ion battery pack is only 1kWh (similar to NiMH in standard Prius) when PiP is 4.4Kwh as fa r as I know. Jacek.
Thank you css28! Jacek.
The P/N of the HV battery assembly is G9280-47190. How to recognize is it ni-mh or li-ion? Thank you, Jacek.
Hi everybody, I have oportunity to buy relatively cheap (~500 USD) 2014 Prius+ battery. As far as I understand European Prius+ is US Prius v...
Exactly. If you look at transaxle crosssection in the Prius Service Manual the oil pump drive shaft is directly driven by input shaft from the ICE...
Hi John, If you can build MMBasic for UBW32/Maximite using MPLAB 8.80 then it should probably run on this board as they are using the same PIC?...
Or.... 6) you can buy this Olimex board Olimex PIC32-MAXI-WEB development board PIC32MX795F512L with ethernet,lcd | eBay and you have...
Hi John, You can probably get up to 8 basic drawing/background colors by cutting this tracks and connecting them to GND/+V respectively. And...
Hi Dutch, Testing is easy... I would attached schematics but due to any reason PriusChat doesen't accept my URL. Configuration is +12V (battery or...
Hi again John, Maybe it's a little off topic here, but have you ever consider paralleling A123 (for high current events) with RFE cells (to...
Hi John, Reading your Prius config description 1 question arises. If you have such good results using BMS+ and your A123 pack then why do you keep...
You can only compare 100mA before with 100mA after the change or 300mA before with 300mA after. If you have higher bleeding current at the...
You can not remove R2A - if you remove it you will get about 2.5V bleeding voltage. Jacek.
Hi Dutch, Removing any of R1 will increase bleeding voltage. I gave you the rule... You can replace R1C (475 = 4.7MOhm) with lets say (225 =...
Hi John, When you open R2 or short R1 then it in theory should start bleeding at 2.5V. But U1B regulator has some accurracy (lets say 5%) so...
According to my calculation your bleeding should start at 3.66V. If you just remove R2D (105 = 1MOhm) you will get 3.61V for start bleeding...
Hi Dutch, It looks like R1/R2 is your voltage divider for U1A shunt regulator. To lower yor shunting (bleeding) voltage you need to decrease R1...
