Separate names with a comma.
To replace the ballast you need to take the whole assembly out pretty sure its on the bottom look on ebay hardest part is getting the headlight...
Save your money on the scanner its a joke, at least they refunded me my money, What is Zero point Calibration? And how is it done?
Check the connection between the steering column and the rack. Remove the boot where the shaft goes threw the firewall next to the gas...
can anyone confirm that post 11 here will work on a 2007?
Ok I reset the abs light at this point I bleed the brakes, every other brakes pedal stroke works the electric pump? well it was reported in...
Yes body shop pulled my abs pump off, messed it all up had to replace it, pissed me off big time. Not sure if the resets even an option at this...
Well I thought the car was stalling, just turned out the gas engine turned off, hey what can I tell you its my first prius! Now to bleed the...
Re: At last some headway Had found a lose ground wire replaced trans, started at last, battery charging. Codes I still have, C1247 Stroke Sensor...
the two plug near the drivers side on the trans has no reading! took the plug off and measured the connector behind the plug, no reading in both!...
Yes have brake codes, abs codes, but i can take care of them when i get the car started, no way to bleed the air out of the system without running...
Is there any way to check transmission ECU and engine ECU before I pull the harness out? One other question, if i do need to replace ecu's do i...
Yes have my eye on one or two will pick up after Easter, hope it does the trick.
All ground points seem to be hooked up. Since then I have got a code reader, codes pulled off car PO351, PO352,PO353,PO354 all related to no spark...
Is there an easy way to checks for shorts in my prius. I have an 07 won't start, I have checked the transmission plugs and there are not in specs!...
