Separate names with a comma.
Can you tell me what manufacturer's product is shown in TMR-JWAP's photos? My '06 that just keeps on going had it's Cat liberated last week while...
Your thread went silent, what was the outcome?
Most likely your 12v battery is bad. Oreilly's is where I've gotten my last 3 12v batteries. The fan noise in the back is the cooling fan for the...
Been off-line for quite sometime so I've only now seen your post. The repair was done on my wife's '09. The ballast was purchased used from an...
In the case of the smart key button, OUT = ON
P0A80 = HV Battery Cell Delta State of Charge Fault. In other words, one or more of the individual cells which make up the pack is outside the...
Ha so now I find the post on the HID warranty extension. Lucky me with 56K on an '09 and a ballast and headlight assembly seal issue but not a...
This is a long post, for instructions on DIY HID ballast removal w/o cutting wires or plastic (it is possible), skip to the end. I over the past...
Leveling Motor
HID lamp connector
And we are out!
Once in the corner there is clearance enough for removal
Slide the connector sideways to the corner
Now past the leveling connector, we are looking through the ballast opening
Work it past the protrusion from leveling connector below. It is a tight fit but should not require excessive force
The flat metal surface of the connector must be held tight to the flat surface of the plastic enclosure
Flip the cover over, remove the black wiring connector (already removed in photo) and the 3 screws
Remove the 4 screws from the corners of the cover.
HID Ballast once removed, note corrosion from water inside light assembly.
So I find myself in the market for replacement HID lamps. From what I been able to determine a D4R is the OEM replacement, but the D4S fits as...
