Separate names with a comma.
Is doing the front much more complicated than the rears?
One of the coils broke on our 2007 Prius… does anyone have any recommendation of a good aftermarket option for the rear suspension kit?
Hey folks, So my replacement modules arrived from 2nd Life Battery, and I pulled the hybrid battery from the car again. I tested all the...
So this is the block (7) that’s failed, and that I should replace one of the modules? [ATTACH]
Thanks mr_guy_mann! I appreciate the clarification. I think I’m going to buy a couple of modules (another post recommended 2nd Life Battery in...
Thanks so much, ChapmanF! Here’s another little nugget of information: I found that when you clear the codes, the triangle and dash warnings...
Update: So, today I removed the battery from the car, and removed all the buss bars, cleaned all corrosion from the buss bars (soaked in white...
One of the Dr. Prius screenshots shows the Full Battery Test, and the test stalled at the “Check Temperatures” stage indicating “Warning! Battery...
Hey folks, So I ordered a Bluetooth OBDII adaptor and used the Dr. Prius app along with the Car Scanner app. Car Scanner reports the following...
How is your experience with the NexCell Lithium?
Thanks for all the advice! Got the Dr.Prius app and ordered one of the Bluetooth OBDII modules recommended on the site. I’m going to test it...
Hey folks, I got the red triangle of death on my 2007 Prius with 268,000 km (166,000 miles) on it. At first I wondered if I had over-filled the...
Is that different from an OBD II code reader that plugs into the car under the dash?
How do you check the code? Is that through the special-diagnostic-headlight-switch menu, or from an OBDII code reader? Thanks so much for the...
Thanks for the tip on the inverter pump. I popped the cap off the reservoir while the car was running (engine actually running), and while there...
Hey folks, I just did an oil change on my Gen 2 (2007), and my wife got the red triangle on her way to work. She came back home, and after the...
Yes, brand new rotor... not that the rotors needed to be replaced. Back before the winter, I had the front bearings done, and the Toyota tech...
Ah-hah! The rust build-up was the culprit! Wire brushed and filed smooth, and now the pads go in! [ATTACH] It's amazing to me that the rotors...
Mendel, thanks for the advice on the Sil-Glyde! It's hard to find in Canada, but I did finally get some.
Okay, so I'm part way through the job, and I'm having a hell of a time getting the new pads into the caliper rails! It's like it's a thousandth...
