Separate names with a comma.
Got it!
Is this the right plug? And after putting in staple to 5 & 7, do I leave it unplugged? And do I need to cut any existing wires? And what position...
If I'm only replacing one TPMS sensor (pre-programmed), do they still need to relearn the other existing three that are already working?
Also, what about first just checking the EGR pipe, which is relatively easy to remove, and if that's clogged, it would be an indication that the...
So, with only 90k, I would hazard a guess that I shouldn't have to deal with the EGR/manifold cleaning for at least another 30-40k, which would...
90k. And there is no way in hell that I would even attempt to pull that EGR valve out and all the work involved doing it! Especially if it's not...
Ok, thanks.
If the engine coolant reservoir is a little bit below the full line, when the engine's cold, should I top it off to the "B" line, or do you do...
If the engine coolant reservoir is a little bit below the full line, when the engine's cold, should I top it off to the "B" line?
the diagram shows the engine coolant reservoir, but where is the reservoir for converter coolant?
When reinstalling the throttle body hose, it seems very easy for the spring clamp to drop a bit below the lip tabs of the hose, which can prevent...
Just bought a new set of rear brake pads. They came with all the clips but it appears that the shims are already attached permanently. It looks...
Here's the official torque spec database for 2001-2012. TOYOTA PRIUS (2001-2012) – TorqueSpec Database
But what are the torque requirements? Are they all the same or different?
I will always do my own engine oil/filter changes. I only need fold down the small flap for that one. Totally unnecessary to remove the entire...
Why isn't it there? Did you buy it used and it wasn't there, or did you just remove it for ease of maintenance for periodic oil changes?
Done! It was much more time consuming doing this job than expected, and very awkward and uncomfortable working under the car with such limited...
I noticed the crush washers are flat on one side and kind of rounded on the other. Which side should go against the transmission case?
Just took it to a local mechanic and let him put it on his lift and he was able to break both the filler and drain plug free for me. He said that...
