Separate names with a comma.
ok i am convince thanks for the thorough explenation
Ok thanks. how you like the venza and is the MPG as good as they say/how is the maintenance reliability factor?
I was in a car accident and my car was hit on the wheel. My car does not pull or veer goes straight for a at least a quarter mile depending on the...
Yea I was paranoid did the same I put in 3 holes. you really just need to bleed the system like ten times never never letting get over 195 during...
same gasket as it will be obvious if it leaks. if it does and you are in a pinch clean it and use the grey gasket seal both sides should work to...
it is my experience that the air gets stuck behind the thermostat not allowing the impeller to do its job like a dry pump it will never do its job...
no, it only went in about 4 inches
no Im talking about the timing chain/engine face cover
IF you swap from gen 3 to gen 4 I advise get the engine as native as possible IE make it gen 3 as best you can replace what you can to make it...
I tried but the chain is in the way and tension must be out in order to get cover on furthermore if you dont want the gasket seal in all the wrong...
I should have taken a pic but just wanted my car up and running but on the Gen 4 there are zigzag plates in the cooling jacket that may cause the...
When I put my engine back together and installed the timing chain tensioner I had seen videos' where the tensioner is not flush and you are...
OK Update, the head gasket was not blown although It looked like it the mayo looked like classic head gasket issue. I thought I had bad gasket or...
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Ok so here are the pics. 1.see the bleeder and bubles do...
yes but you cant do this while you bleed hot coolant.
I can help with your swap call me or email me 831 6013101 [email protected]
I did this swap ran into your issues. 1.make the engine look as much as possible liek the gen 3 I cut the lower mounting bracket on the EGR...
I want to confirm this issue so I realized the coolant one was hot two driveway is on a slight slope. So how long can I leave the car running to...
Yea a gen 4 is what is in there now just wanted to confirm my suspicion.
So confirmed loss of coolant so how can I tell if its the block or the head with the failure. If head I will get a new one.
