Separate names with a comma.
That is good to know. I honestly didn't even think of that but will keep that in mind moving forward. I just went with them because I saw someone...
Hey everyone, just wanted to update the thread. After checking spark plugs, coils, cleaning the MAF, doing a block test, and a few other things, I...
Hey everyone, After driving through some ice and snow on the highway, the plastic guard covering the traction and 12v battery was badly damaged....
That is good to know, I checked the resistances and they were all within spec, so I have been looking for other solutions. Turning my attention...
Hey, I am having an identical issue. Has the injector replacement solution held up? Any regrets about going with the Atlanta Auto rebuilt ones?
This PDF is a great resource, thanks for posting. Any idea where I could find the full manual that this is taken from? Thanks!
I haven't noticed a change in MPG, but I have been in the mountains which adds a lot of variance. I cleaned the throttle body briefly when I did...
I replaced all the plugs with NGK. I replace the coil that gave me the first error, but I just checked and I'm getting misfires on 3 and 4. 3 has...
Forgot to add, each time the shaking has shown up, it has been driven for a while, parked for 10-30 minutes, and started again. From my...
Hey everyone, I recently got a cylinder 4 misfire on my 07, 174k, replaced the spark plugs, as I needed to do that anyway, and it went away. I...
@edthefox5 (sorry for the late reply came home to my internet not working and forgot to reply) It turned out to just be a bent backing plate...
Hey everyone. Yesterday I noticed a grinding sounds (metal on metal as far as I can tell) on sharp right hand turns from my drivers (left) side...
Hey I apologize for the late reply here! I hope you have fixed your problem by now. If not, the issue with mine was that the wire from the battery...
Ah thank you, I measured from that bolt and got 12/13 volts depending on which bolt I go from so the battery appears to be properly grounded. I...
I measured for from the negative terminal to the frame and got from 0.00v to 0.03 volts.
I'm getting the voltage inside the fusable link box where the larger white connector and wire plug into the fusbable link box (at least that is...
Here is the battery, and it is a little harder to see, but I included a picture of me getting voltage at the end of the fusible link box.
The battery is 12v (see pictures below) and with the black lead on the very end of the ground wire it is 12v. However, when I put the black lead...
The 120a fuse passes a visual and voltage test, I am currently looking for a break in the wire but nothing has turned up so far.
[Accidently posted this same post in the newbie forum, though I would try posting in the correct forum!] Hello PriusChat! Here is my situation:...
