Separate names with a comma.
Can the firmware be upgraded on the battery ECU (control computer)? If so, I'd call that "programming the battery" Posted via the PriusChat...
When you cleared the codes with your code reader did the lights go off? I know I had a Bluetooth obd2 reader that actually would make those lights...
Yeah, if they're platinum no need to gap - they're pre-gapped properly. I've never used grease on my Toyotas' boots/coils and have yet to have a...
Following on to what bisco said: These engines start to eat oil like crazy (oil rings get seized), and when the oil runs out the engine perishes,...
SKS switch? .
Was any port in use? That is to say, I once bought a cheap OBDII Bluetooth adapter and ended up getting some very strange communication problems...
Still looking for more used catalytic converters? I have the whole set off of my gen 2 that I replaced .
Black electrical tape is the best solution for that problem! .
It would usually make the key light flash in the error lights section when you press the power button, and the ready does not come on. Putting the...
Did you try jumping the 12v? Be careful as you do this, as always. 11v might not be enough to get the computers to boot up? They have to be booted...
I have wondered the same thing myself. I know AGM is best to help prevent excessive gassing (the battery is inside the passenger compartment after...
It says everything you'd need to know to be able to find a proper inverter that would allow you to supply AC loads from the DC battery packs you...
Did you try putting the key fob into the key slot? I just recently found the battery went dead on my remote key fob and was flashing a yellow car...
Here is some good reading on how folks have used the Prius (and its battery) for home power backup. Lots of good information on this site! The...
Maybe it's a problem with the inverter coolant pump. Check for coolant motion in the inverter coolant reservoir with the car on. It should look...
Thanks for sharing! .
Search around. I think there is a multiple start button press to get the car going after you have the 12v disconnected for a while. It isn't the...
