Separate names with a comma.
Tape alone wouldn’t hold. I tried a couple of different kinds. I only removed the shifter bezel so I could reach in to tighten the bolts. I...
I tried two kinds of tape including 3M trim tape. Nothing would hold. I decided that nobody was ever going to look at that surface so I drilled a...
I actually recommend to my “non tool using” friends that they buy corded tools. I keep my batteries charged because I use them daily. For very...
I have Milwaukee M12 and 18v tools. The 18’s are terrific. The 12’s don’t have the power in comparison. That said, I keep the M12 drill in the...
WD-40 is bad for locks! It dries and causes crap to stick. Use a light spray oil such as tri-flow.
Don’t forget, if you parallel park into a tight spot, the IPA will also drive you out of that spot!
I have 3 radios installed in my gen 4. Dual band mobile 50 watts, 220mhz 5 watts and DMR dual band 5 watts. I have even used them well auto...
Interested
Commercially, card entry on a door is about $3000 each (I’m not kidding). To have a stand alone keypad of commercial quality is about $7-800....
I have used toothpaste to polish out scratches on plastic two-way radio displays. Put a tiny amount on a soft cloth and make small circular...
Pretty useless post without a link! Can you type it in? I don't see it on Carista's web site.
Interesting. I bought my 2017 Prius in September. I asked the dealer about the service interval because I purchased the extended warranty and it...
Rule number one when diagnosing or servicing any battery operated electronic device is change the batteries. It’s cheap, and you get to start from...
Hmm...mine says double that at 16,000km. I have looked for the maintenance schedule and can’t find one. Where did you get your info?
Nope. It has an SMA connector on the end, so it wasn't necessary. Also, I didn't have to drill any holes for coax. I ran the skinny coax in...
Don’t know what you are seeing, but there are screws holding the L brackets.
Nutserts do not require access to the other side of the panel. They are blind fasteners, just like a pop rivet.
Don’t recall what the nutserts are made of. I tend to like stainless, so that might be it. Regarding coax, I bought nmo mounts with the thin...
Well, you are correct on all of the above. However, I'm lazy. I get good signal reports, so I'll leave it at that! Also, I don't think you can...
I attached it to the metal panel. The steel is quite thin. I decided that a regular sheet metal screw didn't have enough thickness to get a good...
