Separate names with a comma.
Thanks for staying with me on this. Regarding cracks I magnafluxed the combustion chamber check for cracks between the valves and around the spark...
I checked the head with a Machinists rule. I sanded the head not the head gasket. I thought about running it until it gets worse and possibly a...
Here's another data point I just remembered. I did change the PCV valve when I did the head gasket. The old one was clicking when shook but a...
It's acting so much like the head gasket is still leaking but as far as I can tell it isn't. I even took a piece of paper towel on a piece of wire...
Yes it had the P0301 before I did the head gasket. Now that code comes and goes as pending and only once or twice has graduated to a current code....
Yeah, that's what I was thinking but why would it be intermittent? It's behaving like a head gasket issue. But I also pressure tested the system...
Yes, I think you're referring to the EGR ports in the manifold. All cleaned out and could blow air through all of them freely
I'm looking for ideas about the possible cause of my cylinder one misfires in my 2012 Prius. This car had a terrible head gasket leak between...
I know this is an older thread but I'm thinking about doing the same thing because I have a spare pack in the garage right now. Here's what I see...
Bumping this old thread in case anyone finds themselves here with the same problem. Mysterious "Park Lock" Red Triangle & my 2005...
Just for anyone else thinking about the IMAX B6AC V2. Don't. I have one for my drone and it can only discharge at about .7amp. It also doesn't...
Thanks. That is helpful. That is the direction I was going because I get an open on the NODD at the converter, instead of 100-150ohm to ground....
Yeah, it's good there.
Hi all. Hoping for some pointers here because I'm stuck. I have an 05' with red triangle, ABS, Brake lights on, as well as the battery and car...
I think I was quite careful to clean up the lip in the knuckle when I had it apart. There had been some corrosion between the knuckle and the...
exactly
I just did my 2008. Remove the knuckle, it's a lot easier. Don't try to reuse the dust shield, get a new one. It pries out with a long screwdriver.
