Separate names with a comma.
Yes, I am leaving the charger/maintainer hooked up to battery when I am running TecStream. Also, I just went out and checked, and I am also...
The 12v battery on my older 2nd Prius went flat, again. I was able to successfully charge it, but got brake warning lights on the dash, again....
My Gen 2 prius went through a lot of problems after sitting unused (Covid), starting with a dead battery (since replaced), dash display...
I'm getting different codes, so I am starting over with a new thread.
OK, I've made some progress. I did get Techstream, and got a C1344 code, as I understand it, a sort of generic brake system malfunction code. I...
I've got it ordered, along with the required cable, I'll post my results once it arrives and I have it up and running.
I am considering getting Techstream and a cable to try to read the codes. Would this be a good idea?
Thanks for the info on the Maint Required light, I remembered that too last night, after I got finished panicking. The combination meter is fine...
Well, now I find that there are even more problems. The maint required light is on, and I drove the car a bit earlier this evening, and, as far as...
I've tried Dr Prius, and all I get are readings on the battery module. When I bridge TC and CG pins, I get a flashing ABS warning light, but it...
I'm using a bluetooth code reader sending to Torque on my phone. For what it's worth, I have also used the jumper wire on the OBD port method, and...
The car only has 77132 miles on it. The brake boost noise only runs for about a second when I turn on the car.
OK, at this point the parking brake light is on (red), also the brake warning light (yellow) and the ABS light (yellow). Now I'm really confused.
The voltage at the switch is 10.48v. So, any ideas of where to look next?
The rear brake shoes are all between 3.38 - 3.83 mm thick, well within the specs. and everything else on the rear brakes look fine, clean, no...
I've scanned for codes, got none. I checked the front pads, they are good. I will check the rear shoes as soon as I can.
I have a 2006 Gen 2 Prius, and the parking brake light stays on when the parking brake is released. I have checked the switch at the back of...
I'm aware of that. I just discovered that the posts were slipping a couple of days ago. i have purchased new OEM clamps and will be changing...
Ahh, but they are not tight. The shims are not allowing me to tighten up the connections very well, I think they are tight, but the next time I...
OK, I mean the MFD and the dash display. I had both of those working just fine the last time I tried the car. I am suspecting a bad battery...
