Jack Stand Placement

The rail that runs along the length of the body has a couple of pairs of notches where the supplied jack is supposed to be placed when raising the car. I would put the jackstands at those points, assuming that the jackstand has a notch to fit the rail.

Can you please scan the page from your owner's manual that says not to use the jack, and post it?

 

The 2008 Owner's manual show the proper places to use with a floor jack, find this on page 362.
On page 363, under When raising your vehicle, a bulleted item says
Lift up the vehicle using a floor jack such as the one shown here in the illustration. (The illustration shows a 4wheeled floor jack)

The next bulleted item says Do not use the floor jack that was supplied with your vehicle.

I guess I never looked, was a cheap floor jack included or is it a scissor jack?

ZC1

 

OK, I think I understand the issue now. Both the rear and the front of the Prius have a central jacking point that allows you to raise up one axle (two wheels) at a time. Those jacking points are intended for a hydraulic floor jack.

The jack supplied with the Prius is intended for use when lifting one corner of the car at a time. That jack is placed between a pair of notches that can be found on the rail that runs along the length of the body.

 

As an FYI, someone posted a long time ago that toyota uses the "rubber bricks" that are notched to fit perfectly with the welds to lift the prius by the frame without damage. If you have the energy, I would hunt a pair of those down, or even make a set from stock hard rubber.I never found a good spot to jack up my (totaled) prius with stand and not cause some paint chips or deformation. The rubber bricks would have been helpful.

 

You could use hockey pucks.

Here is a picture that I took from someone's forum post.

 

I was lifting up the front end of the prius today so I decided to take a few pic a some of the jack and jacking points that I use.

 

I think the issue is that the included jack is not designed to be "man-safe". It's fine for lifting a corner of the car as long as you don't place your body underneath. A sturdy jack stand without hydraulics should be used whenever you're placing yourself in harm's way.

 

Here's a place where you can get both a notched pad for the hydraulic jack to be used on the pinch-weld rail, and a rubber cover for a jackstand to go in the channel next to the rail:

New Page 1 (side lift jack pad)

New Page 1 (jack stand pads)

 

I like the way you replaced the license plate number with your username in the photo. Neat!