1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Disabling the Reverse Beep

Discussion in 'Knowledge Base Articles Discussion' started by Tideland Prius, Sep 8, 2007.

Page 1 of 6
  1. Tideland Prius

    Tideland Prius Moderator of the North
    Staff Member

    Joined:
    Oct 2, 2004
    45,024
    16,242
    41
    Location:
    Canada
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    NOTICE: This works for the 2nd generation Prius. So far, we have no found a solution for European models.

    To eliminate the beeps from seatbelts and reverse, follow these steps:

    1. Power on the car to IG-ON or READY. IG-ON will do for this purpose.
    2. Using the Trip/ODO button, set the Trip/ODO display to ODO (not Trip A or Trip B )
    3. Power off the car.
    4. Now power the car to READY (brake on). This is required so that step 6 works correctly.
    5. Within 6 seconds of powering on, press and hold the Trip/ODO button for 10 seconds or more (there is no indication... just count)
    6. WHILE STILL HOLDING ODO *after* the 10 seconds, shift the "gear" selector to R, then press the P button. Now release the Trip/ODO button.
    7. If the last step was successful, "b on" or "b off" should be displayed in the location where the Trip Odometer or Odometer is normally displayed (front dash area). "b on" is beep on (default), and "b off" is beep off.
    8. Press Trip/ODO to toggle the mode.
    9. Now power the car off to exit the toggle mode.
    10. Power the car on to READY and confirm the reverse beep status by shifting to R. The beep should not be audible if "b off" was selected, and should be audible if "b on" was selected..

    Note: The Repair manual page states that if the the 12v battery is disconnected, the beep will reset to the default of on, and this procedure will need to be performed again - I have confirmed this to be true!. The repair manual also is not clear that Trip/ODO should remain depressed while shifting.

    Additional Note: The driver and passenger seatbelt reminder chime can be disabled or enabled (respectively, defaults are driver on and passenger off) using similar steps. Instead of shifting from P to R to P in step 6, simply buckle then unbuckle the appropriate seatbelt while continuing to depress the Trip/ODO button. Might want a helper for this one!
     
    #1 Tideland Prius, Sep 8, 2007
    hyp3rmil3r, SDB54, DLC82SV and 24 others like this.
  2. fwellers

    fwellers Junior Member

    Joined:
    Oct 21, 2007
    44
    1
    0
    Location:
    Northern Virginia
    I tried this twice on an 08 I just bought last night. It didn't work for me. Both times, after I release the trip/odo button (step6), the dash indicator just goes to TripA.
    Does this not work for 08's ? Any suggestions ?

    Thanks,
    Floyd




    <div class='quotetop'>QUOTE(Tideland Prius @ Sep 8 2007, 11:08 PM) [snapback]509348[/snapback]</div>
     
    #2 fwellers, Oct 21, 2007
  3. fwellers

    fwellers Junior Member

    Joined:
    Oct 21, 2007
    44
    1
    0
    Location:
    Northern Virginia
    Never mind Tideland I did it again, and got it to work.
    The only thing I did different , was to look at the ODO area and see the b off /b on before I powered it off again. For some reason I must've read your instructions wrong.

    Thanks,
    Floyd
     
    #3 fwellers, Oct 21, 2007
    1 person likes this.
  4. JackDodge

    JackDodge Gold Member

    Joined:
    Sep 22, 2005
    2,366
    4
    0
    Location:
    Bloomfield Hills, MI
    Vehicle:
    Other Hybrid
    <div class='quotetop'>QUOTE(Tideland Prius @ Sep 8 2007, 11:08 PM) [snapback]509348[/snapback]</div>
    I forget, does a someone sitting in the front passenger seat cause both reverse beep, and seat belt alarm, set to off to not work or was it just the seat belt? I seem to recall someone stating that just having something heavy in the front passenger seat will do it.
     
    #4 JackDodge, Oct 23, 2007
  5. Tideland Prius

    Tideland Prius Moderator of the North
    Staff Member

    Joined:
    Oct 2, 2004
    45,024
    16,242
    41
    Location:
    Canada
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    I think having someone in the passenger seat for the reverse beep WON'T work but for the passenger seatbelt, you NEED someone in the passenger seat.
     
    #5 Tideland Prius, Oct 23, 2007
  6. ehmcavoy@comcast.net

    [email protected] New Member

    Joined:
    Aug 16, 2007
    3
    0
    0
    Do you have any way of activating beeps for door locking and unlocking. I have basic Prius. It does work with the Smart Key in Option One. Ed
     
    #6 [email protected], Dec 3, 2007
  7. Tideland Prius

    Tideland Prius Moderator of the North
    Staff Member

    Joined:
    Oct 2, 2004
    45,024
    16,242
    41
    Location:
    Canada
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    By default, the car beeps and flashes the indicators when you lock/unlock the car. So someone must've turned it off for you.

    In any case, you'll need to go to the dealer to activate the beep.
     
    #7 Tideland Prius, Dec 3, 2007
  8. tmg

    tmg reset

    Joined:
    Jan 7, 2008
    18
    0
    0
    Location:
    Chicago, IL
    Vehicle:
    2007 Prius
    I do not see any change on the odo. hmmm

    no idea what I am doing wrong.
     
    #8 tmg, Jan 11, 2008
  9. hybridgrl

    hybridgrl New Member

    Joined:
    Jan 1, 2008
    31
    2
    0
    Location:
    Cleveland
    Vehicle:
    2008 Prius
    I do not get why they did not put the beep on the outside of the car?
     
    #9 hybridgrl, Jan 13, 2008
    Hyelite likes this.
  10. aaf709

    aaf709 Ravenpaw of ThunderClan

    Joined:
    Apr 23, 2005
    3,862
    18
    0
    Location:
    San Diego, CA
    Vehicle:
    2022 Prius Prime
    Model:
    Limited
    Because it's a reminder to the driver and wasn't considered was a warning to others. People have done this by disabling the reverse beep and adding some sort of beeper in the back.
     
    #10 aaf709, Jan 13, 2008
  11. PriusRX

    PriusRX New Member

    Joined:
    Dec 27, 2007
    1
    0
    0
    THANK YOU TIDELAND!

    Yes, it works on a 2008 Touring. What an annoyance!

    And no membership fee. AWESOME!
     
    #11 PriusRX, Jan 27, 2008
  12. lumpy95

    lumpy95 Member

    Joined:
    Jan 26, 2008
    394
    63
    2
    Location:
    Mojave Desert, Cal.
    Vehicle:
    2013 Prius
    Model:
    Three
    Thanks Tideland, it worked great on my 2008 touring also.
    It's great to not hear that incessant beeping as I back up.
     
    #12 lumpy95, Jan 29, 2008
  13. Bruce Nyhlen

    Bruce Nyhlen Junior Member

    Joined:
    Jan 30, 2008
    24
    0
    0
    Location:
    Grand Forks, ND
    Vehicle:
    2017 Prius
    Model:
    N/A
    Does the Reverse Beep sound only inside the car, or can people around the car hear it like construction equipment?

    My O5 has it disabled. If it only for the inside, I'll leave well enough alone.
    I was disappointed that is was Disabled since we have a lot of young kids on bikes and big wheels on our street.
     
    #13 Bruce Nyhlen, Feb 4, 2008
  14. Tideland Prius

    Tideland Prius Moderator of the North
    Staff Member

    Joined:
    Oct 2, 2004
    45,024
    16,242
    41
    Location:
    Canada
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    inside only.
     
    #14 Tideland Prius, Feb 4, 2008
  15. airman

    airman New Member

    Joined:
    Jan 10, 2008
    11
    0
    0
    Location:
    Cary NC
    Vehicle:
    2008 Prius
    Just did this to my 2008 Standard and it works. What a difference it makes. Thanks for the mod.......:):) Now it is purrfect:eek:
     
    #15 airman, Feb 14, 2008
  16. peepster

    peepster New Member

    Joined:
    Feb 16, 2008
    1
    0
    0
    Location:
    Phoenix
    Vehicle:
    2008 Prius
    Thanks for the detailed instructions! Success on the first attempt!!!
     
    #16 peepster, Feb 16, 2008
  17. Tsillec

    Tsillec New Member

    Joined:
    Feb 18, 2008
    3
    0
    0
    Location:
    Maryland
    Vehicle:
    2007 Prius
    It took me about a dozen tries before I succeeded in getting the "b on/b off" to show up. I followed the instructions exactly but couldn't get anything but the "Trip A" to display. What finally helped me was to take my foot off the brake when going from reverse to park. Maybe this tip will help others.

    Thanks everyone for the instructions. I'm enjoying the silence.
     
    #17 Tsillec, Feb 22, 2008
  18. Keri

    Keri New Member

    Joined:
    Jul 22, 2007
    65
    0
    0
    Location:
    TEXAS
    Vehicle:
    2008 Prius
    I can't wait until I can finally get a Prius! Tideland is the BomB!
    Now if I could just unload this monster Tahoe................................. :mad: Keri
     
    #18 Keri, Feb 27, 2008
  19. Tideland Prius

    Tideland Prius Moderator of the North
    Staff Member

    Joined:
    Oct 2, 2004
    45,024
    16,242
    41
    Location:
    Canada
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    To all: You're very welcome but I didn't find this. IIRC, I saved it from efusco's KB thread from the old PriusChat so he should get credit for it.
     
    #19 Tideland Prius, Feb 27, 2008
  20. lumpy95

    lumpy95 Member

    Joined:
    Jan 26, 2008
    394
    63
    2
    Location:
    Mojave Desert, Cal.
    Vehicle:
    2013 Prius
    Model:
    Three
    Thank you BOTH :hail:
     
    #20 lumpy95, Feb 28, 2008
(You must log in or sign up to post here.)
Page 1 of 6