1. Attachments are working again! Check out this thread for more details and to report any other bugs.

EV-Peak CQ3 Charger - D.Peak Settings

Discussion in 'Gen 2 Prius Main Forum' started by Kiwi7910, Oct 27, 2023.

  1. Kiwi7910

    Kiwi7910 Junior Member

    Joined:
    Oct 25, 2023
    49
    17
    0
    Location:
    New Zealand
    Vehicle:
    2007 Prius
    Model:
    N/A
    I have an EV-Peak CQ3 charger that I am planning to use to recondition my Gen 2 battery.

    The units of the User Setting "NiMH Sensitivity D.Peak" are mV/cell, but I don't see any way to set the number of cells per module when charging NiMH.
    IMG_20231027_163512_852~2.jpg
    IMG_20231027_163518_892~2.jpg
    So is this setting really mV/cell or is it the total mV per module (string of cells)?
     
    #1 Kiwi7910, Oct 27, 2023
  2. DanielR

    DanielR Junior Member

    Joined:
    May 1, 2023
    10
    2
    1
    Location:
    Virginia
    Vehicle:
    2010 Prius
    Model:
    Three
    My understanding is that, in this case, it’s mV/module.

    I’ve had the best luck with using 1.2A-1.5A discharge to 5.8V. Keep in mind that there are 6 actual cells inside a module, and going lower than 1V per cell is where negative discharge begins, but many of the modules in my 2010 never reached 5,000mAh discharges, even after 8-10 cycles. I was only able to revive them by going lower than 6.0V on a discharge.
     
    #2 DanielR, Dec 14, 2023
  3. JOHN LOFLIN

    JOHN LOFLIN New Member

    Joined:
    Mar 23, 2024
    1
    0
    0
    Location:
    Texas
    Vehicle:
    2012 Prius v wagon
    Model:
    Five
    I’m new here, just got one of these chargers. I set it to 3 Call you later
    Cycles, but it stops at one?
    Any suggestions please.
    Jihn
     
    #3 JOHN LOFLIN, Jun 11, 2024
  4. DanielR

    DanielR Junior Member

    Joined:
    May 1, 2023
    10
    2
    1
    Location:
    Virginia
    Vehicle:
    2010 Prius
    Model:
    Three
    If your cycle reaches a CAPA or charging capacity, it will stop with that cycle. What I do is set the charge capacity to 8,000mAh and just run single cycles when I have this issue.
     
    #4 DanielR, Jun 15, 2024
(You must log in or sign up to post here.)