1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Key Fob get washed &....

Discussion in 'Gen 2 Prius Technical Discussion' started by CWB, Nov 25, 2023.

  1. CWB

    CWB Junior Member

    Joined:
    Feb 5, 2022
    23
    4
    0
    Location:
    Michigan
    Vehicle:
    2008 Prius
    Model:
    II
    I accidentally washed my 2008 key fob. Dried it out and went out to the car and now the door will not open with the key in my hand as the red light won't flash as it reaches the vicinity to be sensed.

    However, when I push unlock, the red light flashes and it unlocks and the car still starts with the key in my hand, not in the slot. Locking works just fine, as well.

    So, the key works... but the sensor range is messed up?

    Any ideas how to fix this or am I going to need to invest in a whole new key?

    Thanks.
     
  2. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    110,166
    50,060
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    how is the battery voltage?
     
  3. CWB

    CWB Junior Member

    Joined:
    Feb 5, 2022
    23
    4
    0
    Location:
    Michigan
    Vehicle:
    2008 Prius
    Model:
    II
    Car battery is fine, it's actually less than two months old... this is right after they key got washed accidentally.
     
  4. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    110,166
    50,060
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    fob battery?
     
  5. JGC61

    JGC61 Active Member

    Joined:
    Mar 8, 2011
    214
    102
    6
    Location:
    Long Island
    Vehicle:
    2021 Prius Prime
    Model:
    Limited
    Washed mine. No problems
    I woulde change the battery.
     
  6. CWB

    CWB Junior Member

    Joined:
    Feb 5, 2022
    23
    4
    0
    Location:
    Michigan
    Vehicle:
    2008 Prius
    Model:
    II
    I shall change the battery
    But.
    I can't get the spare key to come out of the case.. its jammed in there, so I am going to have to get help on that part, for sure.

    Might buy a new case though at least.
     
  7. Tombukt2

    Tombukt2 Senior Member

    Joined:
    Nov 29, 2020
    10,393
    1,797
    0
    Location:
    Durham NC
    Vehicle:
    2009 Prius
    Model:
    Base
    Usually washing the fob ruins it those two of you who've made it through were very lucky It's not normal for this fob to survive at all. Your transponder chip is a sealed unit You won't hurt that that's the little trapezoidal shape thing in the bottom but your green board and all that in the remote usually gets messed up It may unlock the car but it's not transmitting the transponder info or something like that so it doesn't sense that you're near the car with the fob things like that but it seems like it works good enough that when you get in the car you don't have to slot the try changing the round battery and hope for the best.
     
  8. dolj

    dolj Senior Member

    Joined:
    May 14, 2012
    7,855
    3,968
    0
    Location:
    Wellington, New Zealand
    Vehicle:
    2007 Prius
    Model:
    N/A
    Given that your conclusion is that "the sensor range is messed up", I'm going to hypothesize that the little CR2032 battery in the fob was shorted enough to severely discharge it. I'd try replacing the fob battery.
    There is a locking mechanism on the top of the fob (see diagram below). Additionally, if the key and the cover have not been removed in a while they both might be a bit bound in there.

    Note also, that the lock slider needs to be used to release both the key and the cover.
    Prius Gen 2 Key FOB labelled.png
    Change Key Fob Battery.png
     
    #8 dolj, Nov 25, 2023
    Last edited: Nov 25, 2023