OVERHEATING AFTER WATER PUMP REPLACEMENT

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by Allison Meggison, Nov 11, 2019.

Tags:
  1. Allison Meggison

    Allison Meggison Junior Member

    Joined:
    Jun 9, 2019
    71
    6
    0
    Location:
    El cajon
    Vehicle:
    2013 Prius
    Model:
    Two
    My car was going through a lot of coolant before and seemed like the water pump was bad so we replaced it and all was good for a while. Then recently the overheating light started flashing again and will stay solid for a few seconds if I don't slow down or pull over quickly. It's going through coolant really fast again. Idk what the problem is. Looks like coolant is everywhere when I look around the reservoir but I can't tell where it's coming from. Before the water pump replacement I had misfire codes here and there also, even after replacing coils and plugs. There was a water pump code before the replacement. Now no codes pop.
     
    #1 Allison Meggison, Nov 11, 2019
  2. mjoo

    mjoo Senior Member

    Joined:
    Nov 9, 2016
    1,146
    1,326
    12
    Location:
    Michigan
    Vehicle:
    2010 Prius
    Model:
    III
    What mileage? Have you replaced the thermostat? Done an EGR system cleaning?

    Pixel XL ?
     
    #2 mjoo, Nov 11, 2019
  3. Allison Meggison

    Allison Meggison Junior Member

    Joined:
    Jun 9, 2019
    71
    6
    0
    Location:
    El cajon
    Vehicle:
    2013 Prius
    Model:
    Two
    it has 252k miles and no I haven't replaced the thermostat but it was blowing a lot of steam today when I pulled off the interstate after the warning light started flashing. I replaced the cap and the warning light didn't come on for a few hours. Now idk what the problem could be. I don't think I have done the EGR system cleaning.
     
    #3 Allison Meggison, Nov 12, 2019
  4. ASRDogman

    ASRDogman Senior Member

    Joined:
    May 29, 2018
    6,885
    3,626
    0
    Location:
    Florida
    Vehicle:
    2010 Prius
    Model:
    Two
    Anytime you replace the water pump, you should replace the thermostat.
    But it sound like you have a blown head gasket since you state you have steam blowing.
    Depending on where the gasket gives out, the exhaust will blow the coolant back to the overflow tank.
    Had a ford aerostar that did that.
     
    #4 ASRDogman, Nov 12, 2019
    mjoo likes this.
  5. Greenteapri

    Greenteapri Active Member

    Joined:
    Nov 19, 2018
    330
    387
    0
    Location:
    Cypress
    Vehicle:
    2013 Prius
    Model:
    Three
    Steam in the ICE machine is not good.

    How long have you owned the vehicle? How many miles have you put on her?
     
    #5 Greenteapri, Nov 12, 2019
  6. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    111,166
    50,601
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    maybe you didn't get all the air out
     
    #6 bisco, Nov 12, 2019
    mjoo likes this.
  7. Allison Meggison

    Allison Meggison Junior Member

    Joined:
    Jun 9, 2019
    71
    6
    0
    Location:
    El cajon
    Vehicle:
    2013 Prius
    Model:
    Two
    I've had the car a little over a year and I've put about 70k miles on her. She blows steam from the overflow spout on the coolant reservoir near the cap and there's always coolant everywhere but idk where it's coming from. What's the best way to find out where it's coming from? Couldn't I use something to help detect the spot its leaking from?
     
    #7 Allison Meggison, Nov 12, 2019
  8. SFO

    SFO Senior Member

    Joined:
    Feb 7, 2017
    5,302
    4,243
    0
    Location:
    Northern California
    Vehicle:
    2007 Prius
    Model:
    N/A
    What are you replacing the lost coolant with, toyota SLLC or something else?
    Which OBD2 scanner are you using to retrieve stored DTCs?
     
    #8 SFO, Nov 12, 2019
    m.wynn and Raytheeagle like this.
  9. Greenteapri

    Greenteapri Active Member

    Joined:
    Nov 19, 2018
    330
    387
    0
    Location:
    Cypress
    Vehicle:
    2013 Prius
    Model:
    Three


    When in doubt, rev up your engines!
     
    #9 Greenteapri, Nov 12, 2019
    dig4dirt likes this.
  10. Allison Meggison

    Allison Meggison Junior Member

    Joined:
    Jun 9, 2019
    71
    6
    0
    Location:
    El cajon
    Vehicle:
    2013 Prius
    Model:
    Two
    No I was bad and used water a couple times and last time I got the coolant from Auto zone they told me what was best but I haven't gotten it from the dealership in probably five months. I'm using the cheapest scanner tool that you get from walmart that costs $13. It's a tiny little red scanner.
     
    #10 Allison Meggison, Nov 12, 2019
  11. SFO

    SFO Senior Member

    Joined:
    Feb 7, 2017
    5,302
    4,243
    0
    Location:
    Northern California
    Vehicle:
    2007 Prius
    Model:
    N/A
    Water will lower the boiling point.

    A cheap scanner may not pick up all of the codes that are stored.
     
    #11 SFO, Nov 12, 2019
    m.wynn likes this.
  12. Allison Meggison

    Allison Meggison Junior Member

    Joined:
    Jun 9, 2019
    71
    6
    0
    Location:
    El cajon
    Vehicle:
    2013 Prius
    Model:
    Two
    Dang I clicked on those links about oxyclean idk how to even get to the point of cleaning it with oxyclean. How do i know if the thermostat should be replaced? Should I try cleaning it first?
     
    #12 Allison Meggison, Nov 12, 2019
    mjoo likes this.
  13. mjoo

    mjoo Senior Member

    Joined:
    Nov 9, 2016
    1,146
    1,326
    12
    Location:
    Michigan
    Vehicle:
    2010 Prius
    Model:
    III
    At your mileage I would just replace it with a new OEM part. They're around $40

    If you're not getting coolant out the exhaust or misfire codes - a thermostat and EGR cleanse may be all you need.
    Pixel XL ?
     
    #13 mjoo, Nov 12, 2019
    m.wynn likes this.
  14. Allison Meggison

    Allison Meggison Junior Member

    Joined:
    Jun 9, 2019
    71
    6
    0
    Location:
    El cajon
    Vehicle:
    2013 Prius
    Model:
    Two


    What is Pixie XL" lol I'm not sure. What is the best way to clean the EGR
     
    #14 Allison Meggison, Nov 12, 2019
  15. mjoo

    mjoo Senior Member

    Joined:
    Nov 9, 2016
    1,146
    1,326
    12
    Location:
    Michigan
    Vehicle:
    2010 Prius
    Model:
    III
    @Raytheeagle would say pressure washer.

    Pixel XL ?
     
    #15 mjoo, Nov 12, 2019
    m.wynn likes this.
  16. mikey_t

    mikey_t Active Member

    Joined:
    Feb 5, 2019
    370
    391
    0
    Location:
    Los Angeles
    Vehicle:
    2010 Prius
    Model:
    Two
    I think it's a phone that he's using to reply on the forum with, and it auto creates a signature. Like iPhones used to do in emails.
     
    #16 mikey_t, Nov 13, 2019
    mjoo and Raytheeagle like this.
  17. Maximay

    Maximay New Member

    Joined:
    Nov 14, 2019
    1
    1
    0
    Location:
    85251
    Vehicle:
    2012 Prius
    Model:
    Four
    You have a blow head gasket. Your coolant is leaking to the combustion chambers causing misfires. Then blowing out the tail pipe. Exhaust pipe. Need to get a used engine from a donor prius that was in a wreck with low mileage on engine. This happens a lot. And get 2013 and up so the oil ring issue of oil consumption should not surfice
     
    #17 Maximay, Nov 14, 2019
    Mendel Leisk likes this.
(You must log in or sign up to post here.)