1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Bad cell in battery

Discussion in 'Generation 1 Prius Discussion' started by nightmare66, Jan 5, 2019.

  1. nightmare66

    nightmare66 Junior Member

    Joined:
    May 19, 2017
    24
    1
    1
    Location:
    Kentucky
    Vehicle:
    2001 Prius
    Model:
    I
    Code scanner says I have a bad cell on row 13, do i just replace it with one from ebay? I have a bluedriver multimeter is that all i need to test it and the other cells? what do i need to look for?
     
    #1 nightmare66, Jan 5, 2019
  2. bwilson4web

    bwilson4web BMW i3 and Model 3

    Joined:
    Nov 25, 2005
    27,661
    15,662
    0
    Location:
    Huntsville AL
    Vehicle:
    2018 Tesla Model 3
    Model:
    Prime Plus
    It is a little more complicated:
    1. Needs to match the Ahr capacity of the other modules
    2. Needs to be charged to the same level as the other modules
    3. Adjacent modules need to be checked to see if they are weak
    4. First generation modules are weak
    People have done it but the recommended practice is to use Gen-2 or later modules to replace all of them. However, there is a 3d party solution that uses new, "D" cells which looks really good. There would be a challenge with going from 28/2 = 14 modules to 38/2 = 19 modules.

    Bob Wilson
     
    #2 bwilson4web, Jan 5, 2019
    Raytheeagle likes this.
  3. nightmare66

    nightmare66 Junior Member

    Joined:
    May 19, 2017
    24
    1
    1
    Location:
    Kentucky
    Vehicle:
    2001 Prius
    Model:
    I
    Can it be charged with a battery charger while checking with a volt meter?

    Who sells reliable modules? i'm looking for a trusted source for used modules.
     
    #3 nightmare66, Jan 5, 2019
  4. Raytheeagle

    Raytheeagle Senior Member

    Joined:
    Jul 1, 2016
    11,257
    15,491
    0
    Location:
    Bay Area, California
    Vehicle:
    2019 Prius Prime
    Model:
    Prime Plus
    @jeff652 and @TMR-JWAP sell modules.

    They are members here and test them before using.

    Might be worth starting a conversation with them and see what they have.
     
    #4 Raytheeagle, Jan 5, 2019
  5. Brian in Tucson

    Brian in Tucson Active Member

    Joined:
    Oct 15, 2016
    981
    453
    0
    Location:
    Tucson AZ
    Vehicle:
    2003 Prius
    Model:
    N/A
    #5 Brian in Tucson, Jan 5, 2019
  6. Prodigyplace

    Prodigyplace 2025 Camry XLE FWD

    Joined:
    Nov 1, 2016
    11,799
    11,362
    0
    Location:
    Central Virginia
    Vehicle:
    Other Hybrid
    Model:
    XLE
    The 3rd party solution is not for Gen 1 Prius, It looks like you may be able to get a new Toyota battery for about $2000 after returning the core.

    2001 Toyota Prius Parts - metrotoyotapartsnow.com
     
    #6 Prodigyplace, Jan 5, 2019
  7. nightmare66

    nightmare66 Junior Member

    Joined:
    May 19, 2017
    24
    1
    1
    Location:
    Kentucky
    Vehicle:
    2001 Prius
    Model:
    I
    anyone tried these?
     
    #7 nightmare66, Jan 6, 2019
    padroo likes this.
  8. Prodigyplace

    Prodigyplace 2025 Camry XLE FWD

    Joined:
    Nov 1, 2016
    11,799
    11,362
    0
    Location:
    Central Virginia
    Vehicle:
    Other Hybrid
    Model:
    XLE
    Ummm...

    Did you forget something? Try what?
     
    #8 Prodigyplace, Jan 6, 2019
  9. Eric Baker

    Eric Baker Junior Member

    Joined:
    Jan 8, 2018
    8
    12
    0
    Location:
    Blacksburg, VA
    Vehicle:
    2014 Prius v wagon
    Model:
    Two
    I just put a set of 10 of these below in my gen1 pack. I really only needed three but replaced all the lowest measuring modules. I cycled all the cells at 2A discharge down to 6.0V and fully charged at 3A using a Turnigy Reaktor charger/discharger. I ranked by discharge capacity and matched high and low pairs.

    The modules apparently came out of a bus and were in a very low state of charge when I received them. Cycling brought them back after 2-deep discharge/charge sessions with a few days rest between.

    Search Ebay: gen 1.5 prius modules (I can't post link?)

    Overall I am happy with the modules.
     
    #9 Eric Baker, Jan 7, 2019
  10. Eric Baker

    Eric Baker Junior Member

    Joined:
    Jan 8, 2018
    8
    12
    0
    Location:
    Blacksburg, VA
    Vehicle:
    2014 Prius v wagon
    Model:
    Two
    #10 Eric Baker, Jan 9, 2019
(You must log in or sign up to post here.)