Couldn’t press break, then 12v battery died. Replaced it, car won’t drive

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by Msie, Jan 30, 2018.

Page 1 of 2
  1. Msie

    Msie Junior Member

    Joined:
    Jan 19, 2013
    14
    4
    0
    Vehicle:
    2010 Prius
    Model:
    N/A
    I got into my car to go somewhere and couldn’t press the brake to turn on the car. After a few attempts, the battery completely died. I replaced the 12v battery. The car turns on now, but will only let me put it in neutral or park and has an error message that reads “check hybrid system, stop the vehicle in a safe place.”

    Does anyone have an idea what this could be? Do I need to have it towed to a dealership? It’s a 2013 that I bought certified used in 2015.
     
    #1 Msie, Jan 30, 2018
    Last edited: Jan 30, 2018
  2. Prodigyplace

    Prodigyplace 2025 Camry XLE FWD

    Joined:
    Nov 1, 2016
    12,285
    11,620
    0
    Location:
    Central Virginia
    Vehicle:
    Other Hybrid
    Model:
    XLE
    You need the trouble codes read to determine what is wrong. The dealer has the TechStream software recommended for reading the codes on a Prius.
     
    #2 Prodigyplace, Jan 30, 2018
  3. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,600
    8,478
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    Did you touch anything else when you replaced the battery? Like the orange disconnect on the hybrid battery?
     
    #3 JC91006, Jan 30, 2018
    Prodigyplace likes this.
  4. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    111,181
    50,611
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    what the voltage of the new battery?
     
    #4 bisco, Jan 30, 2018
    Prodigyplace likes this.
  5. Msie

    Msie Junior Member

    Joined:
    Jan 19, 2013
    14
    4
    0
    Vehicle:
    2010 Prius
    Model:
    N/A
    Pretty sure it’s 12v; I just took the battery into an o’reilly and they gave me this new one.
     
    #5 Msie, Jan 30, 2018
  6. Msie

    Msie Junior Member

    Joined:
    Jan 19, 2013
    14
    4
    0
    Vehicle:
    2010 Prius
    Model:
    N/A
    No i don’t think so, the battery was basically by itself in the back passenger side of the trunk and I didn’t try anything else.
     
    #6 Msie, Jan 30, 2018
  7. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    111,181
    50,611
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    many (some) new batteries need a charge before installation.
     
    #7 bisco, Jan 30, 2018
  8. Msie

    Msie Junior Member

    Joined:
    Jan 19, 2013
    14
    4
    0
    Vehicle:
    2010 Prius
    Model:
    N/A
    Unrelated, i just want to say I’m pretty embarrassed I wrote “break” twice instead of “brake.”
     
    #8 Msie, Jan 30, 2018
    Prodigyplace, m.wynn and bisco like this.
  9. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    111,181
    50,611
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    i wasn't going to tell anyone.:cool:
     
    #9 bisco, Jan 30, 2018
    MPGesus and m.wynn like this.
  10. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,600
    8,478
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    Could you have accidentally reverse polarity the connections? Tried jump starting? Did it spark when you installed it?
     
    #10 JC91006, Jan 30, 2018
  11. Msie

    Msie Junior Member

    Joined:
    Jan 19, 2013
    14
    4
    0
    Vehicle:
    2010 Prius
    Model:
    N/A
    When the old battery was in the car, we jump started it to see if the battery was dead and if that was the problem. But I carefully followed a couple YouTube videos on replacing the battery and had no issues, and it started right up. Just won’t let me drive it now.
     
    #11 Msie, Jan 30, 2018
  12. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,600
    8,478
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    Try jump starting with the new battery, if you can't get it to READY mode
     
    #12 JC91006, Jan 30, 2018
  13. Msie

    Msie Junior Member

    Joined:
    Jan 19, 2013
    14
    4
    0
    Vehicle:
    2010 Prius
    Model:
    N/A
    Try jump starting it even though it already starts and turns on?
     
    #13 Msie, Jan 30, 2018
  14. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,600
    8,478
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    Oh no, if it's in READY mode. It's ON.

    If it still won't go into drive, it's detecting a problem.

    Try and disconnect the 12v negative for a minute. Then reconnect and try again
     
    #14 JC91006, Jan 30, 2018
    m.wynn likes this.
  15. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,600
    8,478
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    Do you see the READY light in the dash?
     
    #15 JC91006, Jan 30, 2018
  16. Msie

    Msie Junior Member

    Joined:
    Jan 19, 2013
    14
    4
    0
    Vehicle:
    2010 Prius
    Model:
    N/A
    The picture I posted is what I see when I start the car. But it will not let me put the car in reverse or drive, only neutral or park. I’ll try disconnecting the battery and connecting it again.
     
    #16 Msie, Jan 30, 2018
  17. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,600
    8,478
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    I can't see your picture. Your car is not official ON until you see the READY light on the dash and the speedometer showing 0
     
    #17 JC91006, Jan 30, 2018
  18. The Electric Me

    The Electric Me Go Speed Go!

    Joined:
    May 22, 2009
    9,083
    5,800
    0
    Location:
    Undisclosed Location
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    Get's a little semantically messy with a Prius and you say,- On or Ready.
    From the picture, The Prius is at least booting up to the point where you have dash lights and information.
    Which would tell me, power is getting from the 12 volt.
    So I would say your car is turning "On" but not going into Ready state.

    You can endlessly speculate as to what may of happened before replacing the 12 volt battery, you can speculate as to what is happening now.
    But what we do know, is your Prius is booting up, getting to a point, and then giving you a warning message about the Hybrid System. Everything else that is happening or NOT happening after that point is the vehicle protecting itself.
    If it was me? I wouldn't waste time with messing with a lot of disconnecting and reconnecting....I'd simply have it towed to a dealership.
     
    #18 The Electric Me, Jan 30, 2018
  19. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,600
    8,478
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    Since this car is not going into Ready, you should try jump starting it.

    Alternatively you can check the voltage of the new battery and make sure it's at least 12v. A fully charged battery will be close to 13v. If the new battery is under 11v, your car will not start
     
    #19 JC91006, Jan 30, 2018
  20. The Electric Me

    The Electric Me Go Speed Go!

    Joined:
    May 22, 2009
    9,083
    5,800
    0
    Location:
    Undisclosed Location
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    The problems is Prius don't "start" , at least not in the typical ignition sense of a full ICE vehicle.
    Basically Prius "boot up" to a ready state.

    Sure it MAY be a faulty or undercharged brand new 12 volt battery.
    But IMO, I think you can potentially cause more damage if you start connecting and reconnecting things, jump starting batteries that may or may not need to be jump started.

    Since your dash IS lighting up...that would suggest to me that the Prius is at least partially booting up, even if some warning code is keeping it from reaching or allowing the "Ready" state.

    Even if it costs you some money, I don't think you can do wrong following the advice the vehicle itself is giving you. Which is to STOP the vehicle and Check The Hybrid System.

    I would have it towed, and then have the dealership retrieve the codes and "Check The Hybrid System".

    If it turns out it IS just a undercharged new battery, or a simple reconnect solves the problem? Well you only lose some money.

    If you start "guessing" and hooking up jump starts...and connecting and reconnecting things, and possibly doing more damage?
    Well it wouldn't be worth it to me. You could make a simple problem, a whole lot more complicated trying to fix it.
     
    #20 The Electric Me, Jan 30, 2018
    MPGesus and Prodigyplace like this.
(You must log in or sign up to post here.)
Page 1 of 2