Clicking noise when turning corners - normal?

Sounds like one of your CV joints is starting to go out. Any feedback of the clicking through the steering wheel? How many miles? Can you look at your CV joints to see if a boot is split and it has thrown out all the grease? If you turn the wheel all the way you can see one side and they turn all the way to the other side and see the opposite boot.

 

I get the same faint clicking or ratcheting sound. I think it has something to do with the brakes cycling between generative braking and hydraulic application during slow down in at turn. It’s possible it’s the brake caliper and/or brake pads taking and releasing the tolerances in the mechanism. Ever since my car was new, it’s always had an annoying brake snapping noise when contacting Boss Dots or small inclusions in the road surface. In any event, I wouldn’t be too concerned.

 

Just out of the blue......multiple threads show up about the same obscure subject.
This time it's clicking noises.
There is another active thread about it right now.l
Some of the posts there might be helpful.

Another thread about "clicking" probably will pop up in the next few days.

 

DO check that the wheel nuts are properly torqued.

Pearl S doesn't "click" when turning, and I tend to like to go around corners fast.

 

I've noticed it on my 2013 when I go down my parking garage ramp at work. I'm not accelerating, just coasting and just as I get to the bottom and turn right, I hear a click/wining sound.

 

My 2010 has this clicking noise when turning left and braking. Can only hear it with the windows down. Everything feels fine, so I am not concerned with it.

 

My 2010 has the same clicking noise when turning left and braking. Can only hear it with the windows down. Been doing it since I got it, 222K miles now without a problem.

 

Clicking during turns is a classic symptom of CV joint going bad. Is it turns in one direction only? IIRC that could be clincher, and indicates which CV joint is bad.

Totally winging it now, but it might be noise during left hand turns means right CV bad, and vice versa.

And yeah for sure, the low hanging fruit is to check for split boots, flung grease.

 

CV issue like everyone is saying. Mine looked perfect underneath with no leaks or tears but were clicking. Replaced both axle assembly's with CV included. Click free for 25k miles. Check if it's clicking in Neutral under same conditions. Def covered more in depth in another thread. Try to find it.

 

How far can a typical car still be driven safely with clicking noise? And what's the worse thing that can mechanically happen or damage if not taken care of? Thanks.

 

You’ll get tired of the noise before it breaks.

 

Did you ever confirm that it was the CV joint? I'm hearing this now after getting my Prius a few months back.

 

Mine has clicked like that on right turns ever since I got it, 60k miles ago. It does not seem to be worsening. My 1981 Mazda did the same thing.

 

Same here. Mine has been making that noise for the last 62000 miles.

You can experiment and see that the noise goes away if you put the car into neutral as you make the turn. I stopped worrying about it a long time ago.

 

65,000 miles, no clicking