1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Prius won't shift to drive

Discussion in 'Gen 3 Prius Technical Discussion' started by Jaydoc, Feb 15, 2017.

  1. Jaydoc

    Jaydoc Junior Member

    Joined:
    Oct 23, 2015
    30
    5
    0
    Location:
    Birmingham
    Vehicle:
    2010 Prius
    Model:
    III
    Hi all

    My 2010 Prius was parked without being driven for 3 weeks. Now when I push the power button the dash lights up but the ready light stays off and the car won't shift to drive.

    Can someone help me figure this out?

    Thanks
     

    Attached Files:

    #1 Jaydoc, Feb 15, 2017
  2. Buzzhead

    Buzzhead Non-Interference w/ devel of pre-Warp civs

    Joined:
    Aug 15, 2009
    145
    53
    0
    Location:
    Chelmsford, MA
    Vehicle:
    2017 Prius Prime
    Model:
    Prime Advanced
    Possibly the brake switch out of adjustment?
     
    #2 Buzzhead, Feb 15, 2017
  3. mjkcal

    mjkcal Junior Member

    Joined:
    Jan 4, 2010
    10
    3
    0
    Location:
    US
    Vehicle:
    2010 Prius
    Model:
    IV
     
    #3 mjkcal, Feb 15, 2017
  4. mjkcal

    mjkcal Junior Member

    Joined:
    Jan 4, 2010
    10
    3
    0
    Location:
    US
    Vehicle:
    2010 Prius
    Model:
    IV
    The 12 volt battery needs a jumpstart (not the hybrid battery). Instructions begin on p 543 of the Prius 2010 Manual. Your dash lights up because the 12 volt battery is not completely discharged --but enough that it doesn't have enough power to start the car.
     
    #4 mjkcal, Feb 15, 2017
    Montgomery and Jaydoc like this.
  5. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,525
    8,428
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    +1 Most likely dead 12v battery
     
    #5 JC91006, Feb 15, 2017
    Montgomery and Jaydoc like this.
  6. Jaydoc

    Jaydoc Junior Member

    Joined:
    Oct 23, 2015
    30
    5
    0
    Location:
    Birmingham
    Vehicle:
    2010 Prius
    Model:
    III
    Thanks everyone. Like you guys said it was a dead 12v battery. I initially tried to jump start the car using the leads in the front engine compartment fuse box, but that did not work. Had to open the hatch and jump the actual battery in the back. That solved the issue.

    Thanks again.
     
    #6 Jaydoc, Feb 22, 2017
  7. NavyLCDR

    NavyLCDR Active Member

    Joined:
    Oct 15, 2016
    188
    121
    4
    Location:
    Stanwood, WA
    Vehicle:
    2011 Prius
    Model:
    Three
    Just curious, did you try flipping the jumper cable clamp around on the positive terminal in the fuse box? Only one side of the fuse box terminal is metal, and some jumper cables only have one side of the clamp that is connected to the cable so you might not have had metal to conductor contact. Also need to make sure the negative under the hood is connected to a good grounded bolt.
     
    #7 NavyLCDR, Feb 22, 2017
  8. Jaydoc

    Jaydoc Junior Member

    Joined:
    Oct 23, 2015
    30
    5
    0
    Location:
    Birmingham
    Vehicle:
    2010 Prius
    Model:
    III
    I made sure of all that. Flipped up the clamp and made sure there was metal to metal contact at both terminals. Used the bolt that's behind the fuse box as well as the metal arm that holds the hood open as ground terminal contacts, and yet no dice. Used the same battery and cables on the 12v battery itself and got it to work on the first try. Then drove around for 15 mins just to ensure battery for charged up, as a precaution.
     
    #8 Jaydoc, Feb 22, 2017
    carloz562 likes this.
  9. NavyLCDR

    NavyLCDR Active Member

    Joined:
    Oct 15, 2016
    188
    121
    4
    Location:
    Stanwood, WA
    Vehicle:
    2011 Prius
    Model:
    Three
    Strange that the fuse box terminal didn't work especially since the Prius does not take all that much power to jump start like a conventional does.
     
    #9 NavyLCDR, Feb 22, 2017
(You must log in or sign up to post here.)