Airrex on the Red...

Thank you Sean....

 

I think I can go lower..but in the actual measurement..:the front is lower than the rear...
pics front 2.81/ rear 3.00

 

will do...

 

The Side skirts aren't even....not sure how to compare the measurement of height off the ground I just measured the lowest points front and back...

About the water valve's they are already connected, water can be release as a recommendation once a week by pushing a little pin below the filter on to a towel. theres not much moisture more like residual condensation...see pic (actually the valves are mounted..with the pin pointing down)

Also I did get an update about the one sensor/balancing tube question you had....you only need one sensor because the VU Manifold connects both tanks for accuracy.....The VU4...is intelligent...."The robust internal solenoid valve architecture maximizes flow rates, provides bubble-tight sealing, and guarantees operation up to 200 psi for millions of cycles."

Last thing..after I remove the front 15mm spacers, I will get the struts more dialed in and the e level readjusted..then I will be able to go lower....