2007 prius replaced drive battery, will not go in drive

Discussion in 'Gen 2 Prius Technical Discussion' started by Greg Grieve, Jun 16, 2016.

Page 1 of 2
  1. Greg Grieve

    Greg Grieve Junior Member

    Joined:
    Jun 16, 2016
    17
    6
    0
    Location:
    Pa
    Vehicle:
    2007 Prius
    Model:
    N/A
    this car had codes, change drive battery, cell 11 and 12 bad, I changed the drive battery (dorman) cleared all codes, dash lights all off. drove 10miles parked and turned it off, one hour later pushed start button. triagle of death on dash and little car in upper left with exclamation point on screen. will not go in drive or reverse . scan for codes, no codes. inverter pump is running, gas engine is not running to charge drive battery, drive battery is 80% charged. can,t find any rason for this condition. car has 223,500mi. this car is clean through out.
     
    #1 Greg Grieve, Jun 16, 2016
    donthack likes this.
  2. ericbecky

    ericbecky Hybrid Battery Hero

    Joined:
    Mar 12, 2004
    4,379
    3,238
    1
    Location:
    Madison, Wisconsin
    Vehicle:
    2005 Prius
    Model:
    Two
    You will need the codes.
    In the meantime, put your high voltage safety gloves on, and go back and make sure the orange plug is firmly seated.
    Also check your 12v battery voltage. (you don't need High voltage safety gloves for that.
     
    #2 ericbecky, Jun 16, 2016
    Greg Grieve likes this.
  3. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    111,169
    50,602
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    welcome! what are you reading the codes with?
     
    #3 bisco, Jun 16, 2016
    Greg Grieve likes this.
  4. Greg Grieve

    Greg Grieve Junior Member

    Joined:
    Jun 16, 2016
    17
    6
    0
    Location:
    Pa
    Vehicle:
    2007 Prius
    Model:
    N/A
    I have a new 12v battery coming in the morning, I have removed and reinstalled orange plug many times,will check it againg.
     
    #4 Greg Grieve, Jun 16, 2016
  5. Greg Grieve

    Greg Grieve Junior Member

    Joined:
    Jun 16, 2016
    17
    6
    0
    Location:
    Pa
    Vehicle:
    2007 Prius
    Model:
    N/A
    I am using a Actron autoscaner did not wright down codes before drive battery change my bad, but it said bad cells 11 and 12 and replace drive battery
     
    #5 Greg Grieve, Jun 16, 2016
  6. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    111,169
    50,602
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    maybe you need mini vci?
     
    #6 bisco, Jun 16, 2016
    Greg Grieve likes this.
  7. Greg Grieve

    Greg Grieve Junior Member

    Joined:
    Jun 16, 2016
    17
    6
    0
    Location:
    Pa
    Vehicle:
    2007 Prius
    Model:
    N/A
    I am a 35 year mechanic, but never had a prius in my shop,
    what is a mini vci?
     
    #7 Greg Grieve, Jun 16, 2016
  8. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    111,169
    50,602
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    it's the toyota code reader, you can get it on line for cheap and you need an old windows laptop.
    or a dealer can scan it for a hundred bucks or so.
     
    #8 bisco, Jun 16, 2016
    Greg Grieve likes this.
  9. ericbecky

    ericbecky Hybrid Battery Hero

    Joined:
    Mar 12, 2004
    4,379
    3,238
    1
    Location:
    Madison, Wisconsin
    Vehicle:
    2005 Prius
    Model:
    Two
    As part of changing the battery you must clean the hybrid battery fan.
    Double check that the plug for that is fully seated as well. It will prevent the car from starting otherwise.
    The Action should give you most codes.
    Feel free to call me if you still are stuck.
     
    #9 ericbecky, Jun 17, 2016
    Greg Grieve likes this.
  10. Greg Grieve

    Greg Grieve Junior Member

    Joined:
    Jun 16, 2016
    17
    6
    0
    Location:
    Pa
    Vehicle:
    2007 Prius
    Model:
    N/A
    The Hybrid fan had been running all the time with old drive battery, I cleaned it. I will check connection to fan, I have not heard fan run since I changed the drive battery (is it called drive battery or just Hybrid battery?)
     
    #10 Greg Grieve, Jun 17, 2016
  11. M in KC

    M in KC Active Member

    Joined:
    Jun 21, 2014
    358
    106
    0
    Location:
    KC, MO
    Vehicle:
    2005 Prius
    Drive or HV Battery both terms are equally acknowledged on PC. You need to pull your codes. Others have had DTC issues with remanned Dorman batteries, others have had no issues.
     
    #11 M in KC, Jun 17, 2016
    Greg Grieve likes this.
  12. Greg Grieve

    Greg Grieve Junior Member

    Joined:
    Jun 16, 2016
    17
    6
    0
    Location:
    Pa
    Vehicle:
    2007 Prius
    Model:
    N/A
    so I put a new 12v battery in, checked fan connection at HV battery, still will not go in drive or reverse, no codes.
     
    #12 Greg Grieve, Jun 17, 2016
  13. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    111,169
    50,602
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    did you do the proper snap and slide of the high voltage switch on the hv battery? it is not intuitive.
     
    #13 bisco, Jun 17, 2016
    Greg Grieve likes this.
  14. Greg Grieve

    Greg Grieve Junior Member

    Joined:
    Jun 16, 2016
    17
    6
    0
    Location:
    Pa
    Vehicle:
    2007 Prius
    Model:
    N/A
    I think I have it in right, push in slide handle down, I looked at it installed and the little button in the slide that shows in the slot of handle is showing. I took the High volt switch out waited then pushed start button on dash looked at screen and it showed 7 bars on the HV battery, is that normal? how do you tell if HV battery is getting connected to inverter ?
     

    Attached Files:

    #14 Greg Grieve, Jun 17, 2016
  15. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    111,169
    50,602
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    no idea. i'm still thinking codes, but perhaps someone else has a suggestion.
     
    #15 bisco, Jun 17, 2016
    Greg Grieve likes this.
  16. Greg Grieve

    Greg Grieve Junior Member

    Joined:
    Jun 16, 2016
    17
    6
    0
    Location:
    Pa
    Vehicle:
    2007 Prius
    Model:
    N/A
    just got done with work , now i can put my time in this prius prob. I have no code with my scaner, I will get that mini VCI cable. can the mini VCI and toyota code reader pull more codes that my scaner can? (actron code reader plus). why can't the prius just tell me on the screen why it will not start, just a old man thinking out loud.
     
    #16 Greg Grieve, Jun 17, 2016
    bisco likes this.
  17. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    111,169
    50,602
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    i'm no expert, but everything i've read here, nothing reads all toyota codes except tech stream.

    have you checked all the fuses, including high voltage on battery?

    what does the new 12v read when cold and everything off? are the connections good, including ground to body?
     
    #17 bisco, Jun 17, 2016
    Greg Grieve likes this.
  18. Greg Grieve

    Greg Grieve Junior Member

    Joined:
    Jun 16, 2016
    17
    6
    0
    Location:
    Pa
    Vehicle:
    2007 Prius
    Model:
    N/A
    just got done with work , now i can put my time in this prius prob. I have no code with my scaner, I will get that mini VCI cable. can the mini VCI and toyota code reader pull more codes that my scaner can? (actron code reader plus). why can't the prius just tell me on the screen why it will not start, just a
    checked all fuses, under hood and dash, checked that high volt orange plug and the the little shunt in the handle.
    new 12v battery test 540crank amp. all connections are clean. will get back down to my shop in a minute. and check 12v battery installed and connected to car.
     
    #18 Greg Grieve, Jun 17, 2016
    bisco likes this.
  19. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    111,169
    50,602
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    another potential problem is a bad shifter. i think there are threads here.
     
    #19 bisco, Jun 17, 2016
    Greg Grieve likes this.
  20. Greg Grieve

    Greg Grieve Junior Member

    Joined:
    Jun 16, 2016
    17
    6
    0
    Location:
    Pa
    Vehicle:
    2007 Prius
    Model:
    N/A
    the shifter will go in nutral and the park button works. I am going to check inverter coolant senser if it has one and the shifter.
     
    #20 Greg Grieve, Jun 17, 2016
(You must log in or sign up to post here.)
Page 1 of 2