1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Need help on Strut and Springs Installation.

Discussion in 'Gen 3 Prius Main Forum' started by KeKeKeKeViN, Jul 30, 2015.

  1. KeKeKeKeViN

    KeKeKeKeViN Junior Member

    Joined:
    Nov 29, 2013
    15
    14
    0
    Location:
    Sacramento, California
    Vehicle:
    2013 Prius
    Model:
    Five
    Hi. I'm in the process of installing Koni FSD struts and TRD lower springs. While I was disassembling the strut assembly, I forgot to put marks on the strut mounts. Now I can see there is a Green Dot on the mounts but they are same identical parts meaning if one side the Green Dot points outside, the other side will be point the inside. In the past, I've installed strut mounts improperly and it ended up the struts were making crazy clunking noise. Now I really don't wanna screw up again, but stupid me didn't learn my lesson and forgot to put marks. If someone happen to know the proper line up for these mounts, please tell me. Big THX.
     
    #1 KeKeKeKeViN, Jul 30, 2015
  2. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,200
    6,482
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    I looked at the Toyota repair manual which does not provide guidance about the strut mount needing to be oriented in a particular direction. So I would put the top nut on somewhat loosely, enough to hold the strut mount in place when the spring compressors are removed. Then mount the strut in the car, rotating the strut mount as needed to fit the three holes in the coil tower while the bottom of the strut is oriented to fit the steering knuckle.
     
    #2 Patrick Wong, Jul 30, 2015
(You must log in or sign up to post here.)