1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Won't Start - No lights, No response, No noise

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by jlspartz, Jul 6, 2015.

  1. jlspartz

    jlspartz Junior Member

    Joined:
    Dec 2, 2010
    11
    0
    0
    Location:
    WI
    Vehicle:
    2005 Prius
    Model:
    N/A
    I drove my '05 car no problem Saturday night. I went to start it up Sunday and there was no response at all. There's no dome lights, no dash lights, no power button light, nothing... I don't think any light was left on. The 12v battery was replaced about 1 1/2 years ago. I tried jumping it at the front terminal under the hood but still no response. I checked the 120A fuse connected to the 12v battery and it looks fine. I know there's also a 5A small fuse by the 12v battery, but by this time it was getting too dark to check it. Any suggestions?
     
    #1 jlspartz, Jul 6, 2015
  2. alekska

    alekska Active Member

    Joined:
    Feb 14, 2010
    435
    138
    0
    Location:
    Atl
    Vehicle:
    2005 Prius
    Use multimeter. Check the voltage at the terminals under the hood (engine/ground to positive terminal) and at the battery terminals , and tell us. That would be a start of the troubleshooting
    Alex
     
    #2 alekska, Jul 6, 2015
  3. 69shovlhed

    69shovlhed Surly tree hugger

    Joined:
    May 13, 2012
    2,170
    750
    0
    Location:
    Delaware
    Vehicle:
    2017 Prius Prime
    Model:
    Prime Premium
    looking at a fuse isn't a good test. you got to use a meter. also that 12v battery might have an internal short or something.
     
    #3 69shovlhed, Jul 6, 2015
  4. jlspartz

    jlspartz Junior Member

    Joined:
    Dec 2, 2010
    11
    0
    0
    Location:
    WI
    Vehicle:
    2005 Prius
    Model:
    N/A
    I thought I bought a multimeter a couple years ago, but can't find it since moving 6 weeks ago. I'm going to pick a new one up tomorrow, and I will post the results. Thanks!
     
    #4 jlspartz, Jul 6, 2015
  5. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,200
    6,482
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    Try turning on the headlights. If they do not work then you have a problem with the 12V battery or the 120A MAIN fuse. It would be very unusual for that fuse to blow.

    With the jumper cables applied at the jumpstart terminal and unpainted body metal, see if the headlights will turn on. If they do not then there may be a problem with the way you've connected the cables.
     
    #5 Patrick Wong, Jul 6, 2015
  6. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,525
    8,428
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    Do you know how to connect the jumper cables to the terminal in the front of the car? The positive goes on the terminal, the negative goes on an unpainted part of the engine.

    I suspect you have a dead 12v battery
     
    #6 JC91006, Jul 7, 2015
  7. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    110,133
    50,050
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    buy a cheapo multimeter.
     
    #7 bisco, Jul 7, 2015
  8. jlspartz

    jlspartz Junior Member

    Joined:
    Dec 2, 2010
    11
    0
    0
    Location:
    WI
    Vehicle:
    2005 Prius
    Model:
    N/A
    Wow, it's 0.88v at the battery, and 0.5v at the front terminal. I only tried jumping for 2 minutes before. Not sure if it can be saved from complete discharge...
     
    #8 jlspartz, Jul 7, 2015
  9. jlspartz

    jlspartz Junior Member

    Joined:
    Dec 2, 2010
    11
    0
    0
    Location:
    WI
    Vehicle:
    2005 Prius
    Model:
    N/A
    Just got it going again!
    Jumping it from the front under the hood terminal wasn't doing anything. Even while jumping, checking the voltage at the battery it was still 0.88v. I watched 3 videos, all of them showing the same way. The second I hooked up the live car battery to the actual battery in the back the dome door light went on, and it was up and running in a few minutes. I don't know why the terminal under the hood was not working for me.
     
    #9 jlspartz, Jul 7, 2015
  10. Patrick Wong

    Patrick Wong DIY Enthusiast

    Joined:
    Mar 8, 2008
    18,200
    6,482
    0
    Location:
    Green Valley, AZ
    Vehicle:
    2015 Prius
    Model:
    Two
    When the Prius is READY, measure the voltage across the 12V battery as well as at the dedicated jumpstart terminal, to body ground.

    You can try to charge the battery overnight, but you will probably find that it is time to buy a new 12V battery or get a replacement under warranty.
     
    #10 Patrick Wong, Jul 8, 2015
  11. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    110,133
    50,050
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    congratz!
     
    #11 bisco, Jul 8, 2015
  12. Mygirlsprius21

    Mygirlsprius21 New Member

    Joined:
    Dec 13, 2021
    6
    0
    0
    Location:
    Cranston ri
    Vehicle:
    2008 Prius
    Model:
    Base
    #12 Mygirlsprius21, Dec 15, 2021
(You must log in or sign up to post here.)