Hello, I connected the driver's side LED door sill without a problem by following the video instructions. However, there were no instructions for the passenger side. So, I guessed that I would t-tap the two top wires. The LED's do not light up. Now on second view, the top cable that I t-tap'ed looks more black than blue. I should have done this in the light. So... 1) What are the correct wires to t-tap for the passenger side? 2) Did I damage anything if I t-tap'ed the wrong cable and I then remove the t-tap? Thank you very much.
Sorry, I found the full instructions, which I should have followed from the beginning. http://www.juicedhybrid.com/v/vspfiles/assets/images/pt922-47100.pdf Now it seems my power window button doesn't work. The two wires are still intact, but I must have sliced through most of them. Any chance this can be fixed somehow?
i am sure you can find any sort of electrical connection device similar to a vampire clip and bridge the gap that was accidentally created. replacing the harness most likely is pricey, labor intensive and can open up a new can of worms! good luck
Thank you for the replies. Actually, everything works! I tried the power window switch when the car was off, therefore it couldn't have worked. I properly wired the passenger side LED door sills and they light up beautifully. Thank you for hearing me freak out for a little bit. Next, JDM LED headlights!
