How to turn the gas engine "on" after oil change (?????)

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by rrolff, Nov 4, 2009.

  1. rrolff

    rrolff Prius Surgeon

    Joined:
    Aug 19, 2009
    1,610
    246
    0
    Location:
    So Cal
    Vehicle:
    2010 Prius
    Model:
    III
    Basic question - haven't seen much on it... Now I know I wanted 4.25qts, so we went with that - but the mechanic wanted to "check it" after changing.

    We could find no way (in the bay) to turn on the engine. I went to pwr mode to no avail... How do you turn on the engine???
     
    #1 rrolff, Nov 4, 2009
  2. tumbleweed

    tumbleweed Senior Member

    Joined:
    Oct 3, 2005
    4,067
    688
    0
    Location:
    Eastern Oregon
    Vehicle:
    2010 Prius
    Model:
    V
    Turn the car on in the normal fashion, leave it in park then push the gas pedal down and it will start.
     
    #2 tumbleweed, Nov 4, 2009
  3. paprius4030

    paprius4030 My first Prius

    Joined:
    Aug 12, 2004
    2,077
    296
    0
    Location:
    York,Pa.
    Vehicle:
    2012 Prius
    Model:
    Two
    You can also just put it on defrost and max heat that will keep the ICE running.
     
    #3 paprius4030, Nov 4, 2009
  4. ken1784

    ken1784 SuperMID designer

    Joined:
    Dec 18, 2003
    2,943
    1,379
    67
    Location:
    Yokohama, JAPAN
    Vehicle:
    2010 Prius
    Model:
    N/A
    Then, place it in neutral. The engine will continue to run.

    Ken@Japan
     
    #4 ken1784, Nov 4, 2009
    2 people like this.
  5. spiderman

    spiderman wretched

    Joined:
    Jul 5, 2009
    7,543
    1,558
    0
    Location:
    Alaska
    Vehicle:
    2010 Prius
    Model:
    II
    I wonder for how long? Guess I will have to try... thanks.
     
    #5 spiderman, Nov 5, 2009
  6. a64pilot

    a64pilot Active Member

    Joined:
    Aug 3, 2008
    771
    62
    0
    Location:
    Albany Ga.
    Vehicle:
    2010 Prius
    Model:
    III
    I think until it runs out of gas. I don't think the traction battery is charged in neutral either, so eventually you will get a message telling you to put the car in park.
    I haven't done it though, so not sure.
     
    #6 a64pilot, Nov 5, 2009
  7. mani

    mani New Member

    Joined:
    Dec 27, 2013
    3
    2
    0
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    you should do maintaince mode...... to start engine
     
    #7 mani, Dec 27, 2013
  8. szgabor

    szgabor Active Member

    Joined:
    Jul 29, 2009
    994
    175
    0
    Location:
    Oceanside NY
    Vehicle:
    2012 Prius
    Model:
    Two
    only until it completes warm up which may not that long depending on ambient temp.
     
    #8 szgabor, Dec 27, 2013
  9. Alan Claver

    Alan Claver Junior Member

    Joined:
    Sep 4, 2013
    79
    9
    0
    Location:
    Central Pennsylvania
    Vehicle:
    2013 Prius
    Model:
    Five
    It's stated in the manual. In Neutral, the traction battery isn't charged. Which is why Toyota recommends you don't leave the car in Neutral mode in normal operation.
     
    #9 Alan Claver, Dec 28, 2013
  10. ursle

    ursle Gas miser

    Joined:
    Jun 28, 2006
    1,049
    192
    0
    Location:
    NH
    Vehicle:
    2011 Prius
    Model:
    Four
    After I change the oil and want to cycle the ice to then check the oil level I put the car in ready then step on the accelerator, the ice starts, runs for 5 seconds then stops, then I turn the car off and check the oil level (a few minutes later)
     
    #10 ursle, Dec 28, 2013
  11. szgabor

    szgabor Active Member

    Joined:
    Jul 29, 2009
    994
    175
    0
    Location:
    Oceanside NY
    Vehicle:
    2012 Prius
    Model:
    Two
    I correct myself ... :) I tested and yes ICE will not stop even if the warm up is complete ... I watched temp got over 150F and about 10 minutes in the experiment I change to D and ICE stopped.

    Kind of make sense if ICE stopped in Neutral motor generator can not re-start it ...
     
    #11 szgabor, Dec 30, 2013
(You must log in or sign up to post here.)