Anyyone Install Sony CCD Car Rear View Backup Camera w/ Guide Line

Discussion in 'Gen 3 Prius Accessories and Modifications' started by sushiDot, Oct 8, 2013.

  1. sushiDot

    sushiDot Junior Member

    Joined:
    Jul 21, 2013
    36
    1
    0
    Vehicle:
    2013 Prius
    Model:
    Four
    Hello-

    I have a 2013 Prius 4. I am gonna install this camera, wanted to know if anyone with
    a 2013 model have installed this?

    I purchased it on eBay per other recommendations on the site, but it says its for the 2012...I
    am "assuming" there shouldn't be any issues....anyone have any ideas?
    thanks
    j
     
    #1 sushiDot, Oct 8, 2013
  2. sarir97

    sarir97 Member

    Joined:
    Jun 24, 2013
    265
    74
    0
    Location:
    Scottsdale, Arizona
    Vehicle:
    2013 Prius
    Model:
    Four
    Does the guide lines curve with the steering wheel?
     
    #2 sarir97, Oct 8, 2013
  3. sushiDot

    sushiDot Junior Member

    Joined:
    Jul 21, 2013
    36
    1
    0
    Vehicle:
    2013 Prius
    Model:
    Four
    Here is a pic of what it looks like...we hooked it up to a camera to verify it looking sharp before we installed.
    [​IMG]
     
    #3 sushiDot, Oct 10, 2013
  4. sarir97

    sarir97 Member

    Joined:
    Jun 24, 2013
    265
    74
    0
    Location:
    Scottsdale, Arizona
    Vehicle:
    2013 Prius
    Model:
    Four
    And so back to my question, the the lines curve when you turn the steering wheel?
     
    #4 sarir97, Oct 10, 2013
  5. NoMoreNow

    NoMoreNow Member

    Joined:
    May 13, 2013
    167
    102
    0
    Location:
    SF Bay Area
    Vehicle:
    2013 Prius
    Model:
    Two

    I did looked into to this before.....
    Here is the kit connected to the OBD port.

    Not sure if this you were looking for.....

    OBDcamera.jpg

    OBDcamera2.jpg
     
    #5 NoMoreNow, Oct 10, 2013
  6. riceroni87

    riceroni87 Senior Member

    Joined:
    Jul 2, 2013
    360
    598
    10
    Location:
    Oxnard, CA
    Vehicle:
    2013 Prius
    Model:
    Two
    lines dont curve with steering wheel
     
    #6 riceroni87, Oct 10, 2013
  7. sarir97

    sarir97 Member

    Joined:
    Jun 24, 2013
    265
    74
    0
    Location:
    Scottsdale, Arizona
    Vehicle:
    2013 Prius
    Model:
    Four
    But the above pictures suggest that they do? What's the purpose then to tap into the OBD?
     
    #7 sarir97, Oct 10, 2013
  8. riceroni87

    riceroni87 Senior Member

    Joined:
    Jul 2, 2013
    360
    598
    10
    Location:
    Oxnard, CA
    Vehicle:
    2013 Prius
    Model:
    Two
    Ah maybe that thing that connects to obd port. But the camera itself doesnt

    Galaxy Note 2 ? 4
     
    #8 riceroni87, Oct 10, 2013
  9. NoMoreNow

    NoMoreNow Member

    Joined:
    May 13, 2013
    167
    102
    0
    Location:
    SF Bay Area
    Vehicle:
    2013 Prius
    Model:
    Two

    You're need to buy a 12v backup camera with NO LINES, since this IPAS (Intelligent Parking Assist System)
    unit already two dynamic tracks built-in into the IPAS module.

    ""This product works by reading CANBUS data of sensor which provided by the electronic stability program of original vehicle in connection with OBD-u2161 computer port into the unit OBD-II, detecting the rotational rate of steer wheel, car speed and the cars lateral acceleration. By considering the above information, the unit will work out the dynamic track in relation to the static track furnished by the camera , and those will be displayed on the monitor or screen.""
     
    #9 NoMoreNow, Oct 11, 2013
  10. sushiDot

    sushiDot Junior Member

    Joined:
    Jul 21, 2013
    36
    1
    0
    Vehicle:
    2013 Prius
    Model:
    Four
    Ok so the camera i have just has some lines built into the camera feed,

    there is no onboard IPAS that it interfaces with?
     
    #10 sushiDot, Oct 11, 2013
  11. NoMoreNow

    NoMoreNow Member

    Joined:
    May 13, 2013
    167
    102
    0
    Location:
    SF Bay Area
    Vehicle:
    2013 Prius
    Model:
    Two
    Yup, the one u have just Reference Lines built-in, I have the same one too.
    But u can add the IPAS module ($80-$115) to your aftermarket headunit and change camera again with Non-Reference lines.
     
    #11 NoMoreNow, Oct 11, 2013
  12. sushiDot

    sushiDot Junior Member

    Joined:
    Jul 21, 2013
    36
    1
    0
    Vehicle:
    2013 Prius
    Model:
    Four
    Do you know of an IPAS module that is compatable with my unit and where I can find it? I searched for the Yatour unit above couldnt find it .

    also, is there one that will also beep when you get to close or do you need to install
    a seperate sensor unit for that?

    thanks in advance
    j
     
    #12 sushiDot, Oct 11, 2013
  13. djasonw

    djasonw Active Member

    Joined:
    Jul 13, 2004
    952
    116
    0
    Location:
    Coconut Creek, FL
    Vehicle:
    2004 Prius
    Model:
    N/A
    I would like to know what is needed so that the aftermarket backup camera works with my factory unit.


    iPad ? - now Free
     
    #13 djasonw, Oct 14, 2013
  14. riceroni87

    riceroni87 Senior Member

    Joined:
    Jul 2, 2013
    360
    598
    10
    Location:
    Oxnard, CA
    Vehicle:
    2013 Prius
    Model:
    Two
    I used bcus2 wiring harness and an aftermarket backup camera.

    Galaxy Note 2 ? 4
     
    #14 riceroni87, Oct 14, 2013
  15. djasonw

    djasonw Active Member

    Joined:
    Jul 13, 2004
    952
    116
    0
    Location:
    Coconut Creek, FL
    Vehicle:
    2004 Prius
    Model:
    N/A
    Darn, I wish I was handy. I'm just footy.


    iPhone ? - now Free
     
    #15 djasonw, Oct 14, 2013
  16. riceroni87

    riceroni87 Senior Member

    Joined:
    Jul 2, 2013
    360
    598
    10
    Location:
    Oxnard, CA
    Vehicle:
    2013 Prius
    Model:
    Two
    these are what i used. I have a gen3 prius II with non nav. works like a charm





     
    #16 riceroni87, Oct 14, 2013
  17. vandoc

    vandoc Junior Member

    Joined:
    Sep 8, 2013
    7
    0
    0
    Vehicle:
    2013 Prius
    Model:
    II
    Do you get any white pixelation with light colored backgrounds with your setup? I have the Sony camera and Beatsonic adapter, and I sometimes get a little white pixelation with bright backgrounds
     
    #17 vandoc, Oct 14, 2013
  18. riceroni87

    riceroni87 Senior Member

    Joined:
    Jul 2, 2013
    360
    598
    10
    Location:
    Oxnard, CA
    Vehicle:
    2013 Prius
    Model:
    Two
    It flickers sometimes at low light. But not white pixelations with light colors in background. Ill keep an eye out for that next time.

    Galaxy Note 2 ? 4
     
    #18 riceroni87, Oct 14, 2013
  19. riceroni87

    riceroni87 Senior Member

    Joined:
    Jul 2, 2013
    360
    598
    10
    Location:
    Oxnard, CA
    Vehicle:
    2013 Prius
    Model:
    Two
    I had problems with the camera starting up because I wired the camera to the reverse lights. But solved it by running the power wire to the bcus2

    Galaxy Note 2 ? 4
     
    #19 riceroni87, Oct 14, 2013
  20. Frankie Alvidres

    Frankie Alvidres Junior Member

    Joined:
    Jan 13, 2013
    12
    2
    0
    Location:
    SOCAL
    Vehicle:
    2013 Prius
    Model:
    Two
    I have a beatsonic BCUS3 for sale. I changed my mind and cannot return the product where I purchased it. I am going to change my headunit and don't need the beatsonic harness anymore. Message me if interested, I will ship. Very easy to install.
     
    #20 Frankie Alvidres, Oct 25, 2013
(You must log in or sign up to post here.)