Current is always on for windows even I didn't press power button

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by zeba54, Jul 15, 2013.

  1. zeba54

    zeba54 New Member

    Joined:
    Jul 14, 2013
    4
    0
    0
    Vehicle:
    2012 Prius
    Model:
    Two
    After I install a after market backup camera, following problem occurred

    1. After power is complete off, I can still control windows with each button
    2. Have to press window button twice to roll either down or up
    3. Driver side window button can't do 1-click to open window or close. Passenger side has no problem to use door lock or 1-click window control function.
    4. Driver side all window buttons don't work. I can't control the 3 windows beside driver window
    (tried re-program and still didn't work)
    5. Door lock and window lock buttons on driver side don't work. Key fob still works. Luckily

    What thing went wrong?? Really frustrated now!! Any shop in Los Angles can fix these problems? Not dealer. would expect alots to fix these in dealer
     
    #1 zeba54, Jul 15, 2013
  2. 2k1Toaster

    2k1Toaster Brand New Prius Batteries

    Joined:
    Feb 14, 2010
    6,035
    3,855
    0
    Location:
    Rocky Mountains
    Vehicle:
    2006 Prius
    Model:
    Three
    What the heck did you splice into? I am guessing you had to hack into the display, some power source, and the reverse indicator. Anything else? Is this only a backup camera, or are there other functions as well?
     
    #2 2k1Toaster, Jul 15, 2013
  3. Bill Norton

    Bill Norton Senior Member

    Joined:
    Dec 15, 2012
    2,065
    697
    0
    Location:
    MONW, Ks.
    Vehicle:
    2010 Prius
    Model:
    Five
    SOL

    Take it out and try again with different tap-in points?
     
    #3 Bill Norton, Jul 15, 2013
  4. jdcollins5

    jdcollins5 Senior Member

    Joined:
    Aug 30, 2009
    5,131
    1,341
    0
    Location:
    Wilmington, NC
    Vehicle:
    2010 Prius
    Model:
    III
    I agree. Undo the backup camera installation, make sure everything is working correctly and then double check your original connection point or find another tie point.
     
    #4 jdcollins5, Jul 15, 2013
  5. zeba54

    zeba54 New Member

    Joined:
    Jul 14, 2013
    4
    0
    0
    Vehicle:
    2012 Prius
    Model:
    Two
    Yes, You are correct! This is actually what i did. and yet backup camera works = =

    Don't know if I should do this.

    A. Turn the ignition switch ON.
    B. Halfway open the power window by pressing the power window switch.
    C. Fully pull up the switch until the window is full closed and continue to hold the switch for approximately 1 second after the window is fully closed.
    D. Check that the Auto Up/Down function operates normally.
    If not operating normally, follow these steps.
    1. Disconnect the negative battery terminal for 10 seconds.
    2. Connect the battery terminal.
    3. Follow steps A-D above

    But afraid I might erase more default setting.
     

    Attached Files:

    #5 zeba54, Jul 15, 2013
(You must log in or sign up to post here.)