1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Louder horn?

Discussion in 'Gen 3 Prius Accessories and Modifications' started by El Rey San Jose, Oct 19, 2011.

  1. El Rey San Jose

    El Rey San Jose Junior Member

    Joined:
    Jul 12, 2009
    7
    1
    0
    Location:
    San Jose, Ca.
    Vehicle:
    2010 Prius
    Model:
    V
    Anyone have any info about installing a louder horn?
    Thanks, El Rey San Jose....
     
  2. seilerts

    seilerts Battery Curmudgeon

    Joined:
    Mar 7, 2010
    3,326
    1,513
    38
    Location:
    Santa Fe, NM
    Vehicle:
    2005 Prius
    I put Sequoia horns in mine. Others have done Camry.
     
    1 person likes this.
  3. SmellyTofu

    SmellyTofu Average punter

    Joined:
    Dec 20, 2005
    251
    29
    0
    Location:
    Sydney
    Vehicle:
    Other Electric Vehicle
    Model:
    N/A
  4. charlesinoc

    charlesinoc meep meep :-)

    Joined:
    Feb 2, 2011
    60
    3
    0
    Location:
    San Clemente
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    There is a very extensive detailed post on installing a louder horn Generation 3 prius. Do a search.
     
  5. samsprius1

    samsprius1 Active Member

    Joined:
    Jul 19, 2008
    716
    176
    0
    Location:
    USA
    Vehicle:
    2023 Prius
    Model:
    Limited AWD-e
  6. milkman44

    milkman44 Active Member

    Joined:
    Oct 16, 2011
    591
    386
    0
    Location:
    Ky
    Vehicle:
    2010 Prius
    Model:
    II
    My wife totaled our '10 Mazda5 so I'm back to square 1 with a '10 Prius that replaced it. The horn on the 5 was as wimpy as the Prius so I'll be putting these on in a few days. It was an easy upgrade on the Mazda, just a small piece of wire and a couple of fittings to hook them together. Found them cheap here or at a store if you have Harbor Freight near you.

    2 Piece 12 Volt Electric Horn Set
     
  7. mgb4tim

    mgb4tim Noob

    Joined:
    Jul 8, 2009
    1,153
    111
    9
    Location:
    Pittsburgh, PA
    Vehicle:
    2010 Prius
    Model:
    III
    I have these in my Triumph. They are loud
     
  8. mtlewis

    mtlewis Tinkerer

    Joined:
    Oct 5, 2011
    47
    9
    0
    Location:
    Mississippi
    Vehicle:
    2012 Prius
    Model:
    Three
    I put a stebel nautilus compact air horn on my Prius. They say it sounds like a Fiat. It is louder but not sure its worth the money.
     
  9. goodtimes

    goodtimes my future is righteousness

    Joined:
    Sep 13, 2011
    67
    32
    7
    Location:
    California
    Vehicle:
    2011 Prius Alpha
    Model:
    ----USA----
    I just put the Fiamm high/low freeway blasters that I copied from EVPV.... Easy DIY, but I had to remove all the plastic plugs on top of the upper grill to fit my fatass arm through... Other than that... Easy.... These suckers are loud too... More than satisfied... Thanks EVPV & El Rey San Jose on starting this thread!
     
  10. yyyiiikes

    yyyiiikes Junior Member

    Joined:
    May 11, 2007
    84
    15
    0
    Location:
    Austin, TX
    Vehicle:
    2011 Prius
    Model:
    Three
    I had to use the stock horn for the first time today (car is 3 just days old)... a black Escalade didn't see me when changing lanes.

    Let's just say she was not impressed by the sound of protest issued from my car. And I was embarrassed.

    Just placed an order for the FIAMMs.
     
    Dylan Doxey likes this.
  11. DonVentura

    DonVentura SoCal Prius Driver

    Joined:
    Sep 29, 2011
    78
    10
    0
    Location:
    Ventura, CA
    Vehicle:
    2010 Prius
    Model:
    IV
  12. alekska

    alekska Active Member

    Joined:
    Feb 14, 2010
    435
    138
    0
    Location:
    Atl
    Vehicle:
    2005 Prius
    mtlewis,

    did you have to run a new wiring for Nautilus? Or have you used existing setup and just connected it?

    Thanks,
    - Alex


     
  13. jsmithy

    jsmithy Hypermiler and Freedom Lover

    Joined:
    Sep 19, 2007
    75
    15
    0
    Location:
    MO
    Vehicle:
    2010 Prius
    Model:
    II

    Stebel's require a relay. You can use the stock horn wires to trigger the relay, but the power has to come directly from the battery. As I recall, one draws ~18 amps.
     
    1 person likes this.
  14. Maine Pilot

    Maine Pilot Senior Member

    Joined:
    Mar 30, 2011
    166
    504
    0
    Location:
    Saco, Maine
    Vehicle:
    Other Hybrid
    Model:
    III
    I've installed the Nautilus on my MX-5 (Miata). Our o.e.m. horns are much quieter than the Prius'--and we're a smaller vehicle. Installation is more difficult than on the Prius.

    The Nautilus does not require a relay--you can swap it out for your own horn without much difficulty. I'm not sure what the amp value of the Prius' horn circuit breaker is. Not withstanding JSMITHY's response, it may be the MX-5's c.b. has a higher value than the Prius.

    I've had two Nautilus' on two different cars and they both "died" after 18-24 months; possibly due to moisture. One fix is to spray some WD-40 into the horn's intake, but that gave only a temporary respite. Others on the miata.net have had good results with the horn, but given my experience, I'm ready for something else.

    I've decided to get a salvaged horn from a big honk'n American-made land cruiser as a permanent fix. Yes, it will need a relay, but it'll be worth the extra effort.
     
  15. ImeanGreen

    ImeanGreen Prius v Five BP Brigade #236

    Joined:
    Feb 20, 2012
    547
    73
    0
    Location:
    Somewhere out there
    Vehicle:
    2011 Prius
    Model:
    Two
    I was planning to install the Stebel Nautilus horn in my pri but the issue that I am having with them is it's reliability. They are really loud though.
     
  16. jsmithy

    jsmithy Hypermiler and Freedom Lover

    Joined:
    Sep 19, 2007
    75
    15
    0
    Location:
    MO
    Vehicle:
    2010 Prius
    Model:
    II
    I use the Stebel Compact Nautilus on my dual sports bikes. I slip a piece of clear fuel tubing over the intake and run it up into a "clean" area, usually under the seat, so water/dirt/mud doesn't enter the intake. Three years later they have not failed yet. I also slip an old sock over the whole horn when lots of dust or mud is involved to protect the outlet.
     
  17. mtlewis

    mtlewis Tinkerer

    Joined:
    Oct 5, 2011
    47
    9
    0
    Location:
    Mississippi
    Vehicle:
    2012 Prius
    Model:
    Three
    Alekska,
    Sorry, haven't been on for a while. I just ordered the wiring kit that Amazon offers for the horn. It includes a relay but my horn came with a relay also. It would be better to use the relay and wiring kit because the Stebel draws more amperage than your stock horns.
    That being said I have since changed my horn again. This time to the Fiamms offered on Amazon I think.