1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Cup Holder LED

Discussion in 'Gen 2 Prius Accessories & Modifications' started by martyoh, Oct 8, 2011.

  1. martyoh

    martyoh New Member

    Joined:
    Sep 4, 2011
    12
    7
    10
    Location:
    Orange County, CA
    Vehicle:
    2005 Prius
    Model:
    V
    Disclaimer: Will void warranty on your products. Not responsible for damage or personal injury. The purpose of this thread is to informational only. I TAKE NO RESPONSIBILITY FOR YOUR OUTCOME.

    Cost: Free (I had some left over LED stripe)
    Time: 1 Hours
    Skill: Easy: Tools: Screw Driver, Soldering Gun, Electrical Tape, Thin wires (I used left over speaker wires).

    Nice to know:
    1. Basically taped LED Strip inside cup holder and connected wire to center console 12V power by removing rear cup holder assembly (no screws).
    2. Easier than I thought.

    See photos for illustrated instruction.

    Enjoy
     

    Attached Files:

    Sezy likes this.
  2. green4u

    green4u New Member

    Joined:
    Mar 18, 2011
    115
    10
    0
    Location:
    CA
    Vehicle:
    2006 Prius
    Model:
    N/A
    Nice! I would get a bigger LED strip to use

    Someone's already done this before too. Darelldd.


     
    1 person likes this.
  3. osofast10

    osofast10 New Member

    Joined:
    Jan 10, 2011
    61
    0
    0
    Location:
    Va
    Vehicle:
    2005 Prius
    Model:
    N/A
    ''


    i was thinking about doing this same mod... nice to know someone already did it... :rockon:
     
  4. martyoh

    martyoh New Member

    Joined:
    Sep 4, 2011
    12
    7
    10
    Location:
    Orange County, CA
    Vehicle:
    2005 Prius
    Model:
    V
    green4u, much nicer implementation than mine.
    very professional job!
     
  5. green4u

    green4u New Member

    Joined:
    Mar 18, 2011
    115
    10
    0
    Location:
    CA
    Vehicle:
    2006 Prius
    Model:
    N/A