cutaway or diagram for replacing mirror

Can;t paste pictures here, but:

REMOVAL​

HINT:
• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.​

1. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
2. REMOVE FRONT DOOR LOWER FRAME BRACKET
GARNISH LH (See page ​

​

​

​

ED-11)
3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH
(See page ED-11)
4. REMOVE DOOR PULL HANDLE (See page ED-11)
5. REMOVE FRONT ARMREST UPPER BASE PANEL
LH (See page ED-11)
6. REMOVE FRONT DOOR TRIM BOARD SUBASSEMBLY
LH (See page ED-12)
7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
LH (See page MI-9)
8. REMOVE FRONT DOOR BELT MOULDING
ASSEMBLY LH​

(a) Put protective tape under the moulding.
(b) Using a moulding remover, detach the claws to
remove the moulding as shown in the illustration.
HINT:
Tape the remover tip before use.​

Moulding Remover
Protective Tape​

B074194E02​

EXTERIOR ​

​

​

​

​

– FRONT DOOR BELT MOULDING ET–21​

ET​

INSTALLATION​

HINT:
• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.​

1. INSTALL FRONT DOOR BELT MOULDING
ASSEMBLY LH​

(a) Attach the claws to install the moulding.
HINT:
Confirm that the moulding is firmly installed.​

2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY
LH (See page ​

​

​

​

MI-13)
3. INSTALL FRONT DOOR TRIM BOARD SUBASSEMBLY
LH (See page ED-21)
4. INSTALL FRONT ARMREST UPPER BASE PANEL LH
(See page ED-21)
5. INSTALL DOOR PULL HANDLE (See page ED-22)
6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH
(See page ED-22)
7. INSTALL FRONT DOOR LOWER FRAME BRACKET
GARNISH LH (See page ED-22)
8. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
9. PERFORM INITIALIZATION​

(a) Perform initialization (see page ​

​

​

​

IN-32).​

NOTICE:
Certain systems need to be initialized after
disconnecting and reconnecting the cable from​

the negative (-) battery terminal.

 

There is another thread answering the same question:
http://priuschat.com/forums/gen-ii-...hooting/58015-how-replace-drivers-mirror.html

 

[

Marnius'prius,

I'm not sure if you are still in need of a side view mirror diagram but I found a simple from 2007 Toyota PRIUS 10622 87-01 Mirror Parts | Genuine OEM Toyota Parts:



Let me know if you have any questions with the job!