1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Maintenance Mode for Gen III

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by jdcollins5, Nov 9, 2009.

  1. jdcollins5

    jdcollins5 Senior Member

    Joined:
    Aug 30, 2009
    5,131
    1,340
    0
    Location:
    Wilmington, NC
    Vehicle:
    2010 Prius
    Model:
    III
    I have searched and cannot find any link to a description of getting in to Maintenance Mode for the Gen III vehicles, only for Gen II. If I have missed a link, I apologize and would appreciate someone pointing me to this link.

    Question - Is the sequence of steps for getting in the Maintenance Mode the same for the Gen III as for the Gen II?
     
  2. RodJo

    RodJo Member

    Joined:
    May 30, 2009
    423
    56
    0
    Location:
    Boston
    Vehicle:
    2010 Prius
    Model:
    V
    What do you mean by Maintenance Mode? Are you referring to the menu to input maintenance information (oil change, tire rotation, etc.) or to the finger dance to get to the hidden service menu?
     
  3. jdcollins5

    jdcollins5 Senior Member

    Joined:
    Aug 30, 2009
    5,131
    1,340
    0
    Location:
    Wilmington, NC
    Vehicle:
    2010 Prius
    Model:
    III
    To the hidden service menu. The one that you can check HV battery voltage, etc.
     
  4. RodJo

    RodJo Member

    Joined:
    May 30, 2009
    423
    56
    0
    Location:
    Boston
    Vehicle:
    2010 Prius
    Model:
    V
    Push SETUP and then DISP and you will see horizontal lines. On the left side of the screen press top line, bottom line, top line, bottom line for a few times (I forget whether its 3 or 4 cycles) until the screen changes. (It might take a few tries to get the dance right, but it does work.) Then select the settings menu.....

    When you are done, press and hold DISP.
     
  5. RodJo

    RodJo Member

    Joined:
    May 30, 2009
    423
    56
    0
    Location:
    Boston
    Vehicle:
    2010 Prius
    Model:
    V
    OK, I just tested it to make sure I was right. Actually press below the top line and above the bottom line for 3 cycles. But I did not see the Traction Battery voltage in there...
     
  6. HTMLSpinnr

    HTMLSpinnr Super Moderator
    Staff Member

    Joined:
    Dec 8, 2003
    5,341
    920
    251
    Location:
    Surprise, AZ (Phoenix)
    Vehicle:
    2018 Tesla Model 3
    Model:
    N/A
    I don't believe Traction battery voltage was *ever* part of that screen - the screen only displayed information fed into the NAV/Audio system via direct input or AVC LAN.
     
  7. jdcollins5

    jdcollins5 Senior Member

    Joined:
    Aug 30, 2009
    5,131
    1,340
    0
    Location:
    Wilmington, NC
    Vehicle:
    2010 Prius
    Model:
    III
    Thanks for the sequence to get to the hidden service menu. As for the battery voltage, I was reading another thread where someone was explaining how to read and test the battery voltage. Could this have been the 12V battery ?
     
  8. RodJo

    RodJo Member

    Joined:
    May 30, 2009
    423
    56
    0
    Location:
    Boston
    Vehicle:
    2010 Prius
    Model:
    V
    Could that thread have been talking about ScanGauge or something else that plugs into the OBD port?
     
  9. jdcollins5

    jdcollins5 Senior Member

    Joined:
    Aug 30, 2009
    5,131
    1,340
    0
    Location:
    Wilmington, NC
    Vehicle:
    2010 Prius
    Model:
    III
    No, the person gave instructions of how to get the Gen II in what he called Maintenance Mode and then how to get to the battery voltage page, etc. He went through a similar sequence that you described for getting in to this mode. This is what got me thinking of how to get in this mode in a Gen III.
     
  10. jdcollins5

    jdcollins5 Senior Member

    Joined:
    Aug 30, 2009
    5,131
    1,340
    0
    Location:
    Wilmington, NC
    Vehicle:
    2010 Prius
    Model:
    III
    I tried this several times with no luck. I saw on another post where they instructed to press the Info button and turn the headlights on and off three times. I tried this one and it changed to the Service Menu screen.

    One of the menu items was Vehicle Signals. One of the signals listed here was battery voltage which was the 12V battery signal.

    Is this the same Service Menu you were able to get with the Settings and Display buttons and the two horizontal lines?
     
    WienerMobile, telmo744 and djm like this.
  11. RodJo

    RodJo Member

    Joined:
    May 30, 2009
    423
    56
    0
    Location:
    Boston
    Vehicle:
    2010 Prius
    Model:
    V
    Yes, sounds like it.
     
    1 person likes this.
  12. jdcollins5

    jdcollins5 Senior Member

    Joined:
    Aug 30, 2009
    5,131
    1,340
    0
    Location:
    Wilmington, NC
    Vehicle:
    2010 Prius
    Model:
    III
    RodJo,

    Can I get you to step through the sequence of the Setup and Display buttons and the two horizontal lines, one more time? Just for the heck of it I would like to figure out why I cannot get this dance right on my car but you can on yours.
     
    1 person likes this.
  13. RodJo

    RodJo Member

    Joined:
    May 30, 2009
    423
    56
    0
    Location:
    Boston
    Vehicle:
    2010 Prius
    Model:
    V
    Better yet, I looked through my old posts and found the YouTube video (authored by HTMLSpinnr no less) where I learned it.

    [ame="http://www.youtube.com/watch?v=-gwQpvpYVYg&feature=channel_page"]YouTube - 2010 Toyota Prius Bluetooth microphone volume adjustment[/ame]

    It can be a little tricky but I think you may have to wait for the Navi to fully boot up and connect to any bluetooth devices etc. before it recognizes the dance.

    Good luck.
     
  14. jdcollins5

    jdcollins5 Senior Member

    Joined:
    Aug 30, 2009
    5,131
    1,340
    0
    Location:
    Wilmington, NC
    Vehicle:
    2010 Prius
    Model:
    III
    RodJo,

    That is the same Service Menu screen that I was able to get to with the Info button and the headlights.

    There is a lot of useful information on this menu screen. I even noticed where you can adjust the Handsfree microphone volume, press a Record button, speak in to the microphone and then play your voice back to hear the volume level !!

    Thanks so much for your assistance,

    Dwight
     
  15. jdcollins5

    jdcollins5 Senior Member

    Joined:
    Aug 30, 2009
    5,131
    1,340
    0
    Location:
    Wilmington, NC
    Vehicle:
    2010 Prius
    Model:
    III
    RodJo,

    After watching the video I was able to get the Service Menu on first try. My problem was that I was trying not to hit the buttons on the screen on the left side. I was trying to go between the buttons and the side, thinking that the buttons would interfere.

    A picture is worth a thousand words is true once again.

    Thanks,

    Dwight
     
  16. mani

    mani New Member

    Joined:
    Dec 27, 2013
    3
    2
    0
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    gen # 3 maintaince mode...

    press 2 times start buttuon

    press 2 times gas padel
    hold brake padel put P to N
    press 2 times gas padel
    hold brake padel put N to P
    press 2 times gas padel again
    put foot brake padel and start engine............

    engine become inspecion mode/maintainence mode........
     
    jack black and HomeyClown like this.