1. Attachments are working again! Check out this thread for more details and to report any other bugs.

How to turn the gas engine "on" after oil change (?????)

Discussion in 'Gen 3 Prius Care, Maintenance & Troubleshooting' started by rrolff, Nov 4, 2009.

  1. rrolff

    rrolff Prius Surgeon

    Joined:
    Aug 19, 2009
    1,610
    246
    0
    Location:
    So Cal
    Vehicle:
    2010 Prius
    Model:
    III
    Basic question - haven't seen much on it... Now I know I wanted 4.25qts, so we went with that - but the mechanic wanted to "check it" after changing.

    We could find no way (in the bay) to turn on the engine. I went to pwr mode to no avail... How do you turn on the engine???
     
    #1 rrolff, Nov 4, 2009
  2. tumbleweed

    tumbleweed Senior Member

    Joined:
    Oct 3, 2005
    4,067
    688
    0
    Location:
    Eastern Oregon
    Vehicle:
    2010 Prius
    Model:
    V
    Turn the car on in the normal fashion, leave it in park then push the gas pedal down and it will start.
     
    #2 tumbleweed, Nov 4, 2009
  3. paprius4030

    paprius4030 My first Prius

    Joined:
    Aug 12, 2004
    2,077
    296
    0
    Location:
    York,Pa.
    Vehicle:
    2012 Prius
    Model:
    Two
    You can also just put it on defrost and max heat that will keep the ICE running.
     
    #3 paprius4030, Nov 4, 2009
  4. ken1784

    ken1784 SuperMID designer

    Joined:
    Dec 18, 2003
    2,943
    1,378
    67
    Location:
    Yokohama, JAPAN
    Vehicle:
    2010 Prius
    Model:
    N/A
    Then, place it in neutral. The engine will continue to run.

    Ken@Japan
     
    #4 ken1784, Nov 4, 2009
    2 people like this.
  5. spiderman

    spiderman wretched

    Joined:
    Jul 5, 2009
    7,543
    1,558
    0
    Location:
    Alaska
    Vehicle:
    2010 Prius
    Model:
    II
    I wonder for how long? Guess I will have to try... thanks.
     
    #5 spiderman, Nov 5, 2009
  6. a64pilot

    a64pilot Active Member

    Joined:
    Aug 3, 2008
    771
    62
    0
    Location:
    Albany Ga.
    Vehicle:
    2010 Prius
    Model:
    III
    I think until it runs out of gas. I don't think the traction battery is charged in neutral either, so eventually you will get a message telling you to put the car in park.
    I haven't done it though, so not sure.
     
    #6 a64pilot, Nov 5, 2009
  7. mani

    mani New Member

    Joined:
    Dec 27, 2013
    3
    2
    0
    Vehicle:
    Other Non-Hybrid
    Model:
    N/A
    you should do maintaince mode...... to start engine
     
    #7 mani, Dec 27, 2013
  8. szgabor

    szgabor Active Member

    Joined:
    Jul 29, 2009
    994
    175
    0
    Location:
    Oceanside NY
    Vehicle:
    2012 Prius
    Model:
    Two
    only until it completes warm up which may not that long depending on ambient temp.
     
    #8 szgabor, Dec 27, 2013
  9. Alan Claver

    Alan Claver Junior Member

    Joined:
    Sep 4, 2013
    79
    9
    0
    Location:
    Central Pennsylvania
    Vehicle:
    2013 Prius
    Model:
    Five
    It's stated in the manual. In Neutral, the traction battery isn't charged. Which is why Toyota recommends you don't leave the car in Neutral mode in normal operation.
     
    #9 Alan Claver, Dec 28, 2013
  10. ursle

    ursle Gas miser

    Joined:
    Jun 28, 2006
    1,049
    192
    0
    Location:
    NH
    Vehicle:
    2011 Prius
    Model:
    Four
    After I change the oil and want to cycle the ice to then check the oil level I put the car in ready then step on the accelerator, the ice starts, runs for 5 seconds then stops, then I turn the car off and check the oil level (a few minutes later)
     
    #10 ursle, Dec 28, 2013
  11. szgabor

    szgabor Active Member

    Joined:
    Jul 29, 2009
    994
    175
    0
    Location:
    Oceanside NY
    Vehicle:
    2012 Prius
    Model:
    Two
    I correct myself ... :) I tested and yes ICE will not stop even if the warm up is complete ... I watched temp got over 150F and about 10 minutes in the experiment I change to D and ICE stopped.

    Kind of make sense if ICE stopped in Neutral motor generator can not re-start it ...
     
    #11 szgabor, Dec 30, 2013
(You must log in or sign up to post here.)