Gen 2 Loose bumper fix with Gen 3 Kenstyle plate?

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by coyote2, Mar 28, 2022.

  1. coyote2

    coyote2 Member

    Joined:
    Jun 29, 2004
    128
    30
    0
    Vehicle:
    2005 Prius
    Model:
    Two
    There's a big helpful thread on loose Gen 3 bumpers. I wonder if the Gen 2 bumper is similar enough that the pre-made 'Kenstyle' reinforcement plates for use on Gen 3 will work on my (2005) Gen 2 too? LeftRear.jpg RightFront.jpg
     
    #1 coyote2, Mar 28, 2022
  2. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,601
    8,478
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    That gen2 gap is nothing compared to the gen3 gap. The gen3 cars looks like the bumper is about to fall off
     
    #2 JC91006, Mar 28, 2022
  3. coyote2

    coyote2 Member

    Joined:
    Jun 29, 2004
    128
    30
    0
    Vehicle:
    2005 Prius
    Model:
    Two
    I hear you, JC91006. Admittedly this feels like a cosmetic issue; it's the pressing it in every time I pass it that is making me nuts.
     
    #3 coyote2, Mar 28, 2022
  4. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,601
    8,478
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    I actually go through that with my Gen3 car LOL. This normally happens when the bumper is a replacement bumper and is not an original Toyota part.
     
    #4 JC91006, Mar 28, 2022
  5. coyote2

    coyote2 Member

    Joined:
    Jun 29, 2004
    128
    30
    0
    Vehicle:
    2005 Prius
    Model:
    Two
    My bumper is original Toyota; but it's driven to the Arctic Ocean coast of Alaska on the Dalton Highway where no sane person takes a Prius.
     
    #5 coyote2, Mar 28, 2022
  6. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,601
    8,478
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    You can try removing it and see if all the side clips/attachment points are intact. There is also the piece that the bumper sides attaches to on the car body, that part normally goes bad.
     
    #6 JC91006, Mar 28, 2022
(You must log in or sign up to post here.)