What did you do to ur Gen III Prius today????

Minimum disassembly. You can use the existing connector in the OEM speaker to transfer over to the new speakers for plug and play.

 

Did the same this week , and front doors speakers too, what an improvement!!! Choose to flush install using the grids for supporting the tweeters , looks good and sounds amazing !! Had to cut bottom side of speakers baffles because it was killing the sound, just wanted to protect the speakers from water...

 

Thanks to Priuschat I installed LED side mirrors! Also added vinyl wrap, TRD springs, and spray painted the stock hubcaps.

No one knows it’s a base model with 213k miles! The EGR was the only issue it had.

 

You should paint the wheel covers red to match the car.

 

Lol really?

IG: twnzy_

 

Yes, really. The "silver" on the wheel covers would look better in red.

 

So, I bought my 2012 knowing there wasn't a good place (subjective!) to stick my phone while driving. The front cupholder (the one with the lid) is ok with the lid open and no drink there. The little slot between the two cupholders would be perfect if it was about 2-3 inches deeper so the phone didn't fly out when turning corners. Has anyone figured out a way to make this happen in a clean way?

No, I don't want a phone mount. The lower tray down by the 12v and seat heater controls is too low for my tall self.

 

This is what im using

amazon.com/Nimbus-Mount-Co-TNM1-The/dp/B00X2UEP5Q/

 

I played a little with Techstream and modified odometer to know how will appear when close to 1 million...
Also is displayed maximum speed.

 

So you reset the odometer?

 

No, it was only a test, after I closed the test, the odometer goes to old value...

 

Friday.
G front bumper. Test fit Tom's lip.


Yesterday.

Trust Beat Max Ti.

No, it is not loud and there isn't a sound clip. You hear a low rumble when you turn the car on.

IG: twnzy_
View attachment 208255

 

replacement engine is in
replacement engine harness is in
runs smooth
no leaks

waiting on new battery pack

 

Where were you able to purchase the springs?

 

But keep the toyota emblem original. It will pop.

 

Yep! Either paint the "T" red and the background black, or the "T" black and background red.

 

A little bit of autocrossing in the PNW. After the last round of chassis stiffening I've hit the limits of the Tein springs. Next up I need to find a nice set of coilovers for street and track use.

 

I have a set of Tein's if you're interested. I'm in the PNW too. (reach out to me at shaotai at gmail dot com)

 

I modified my bumper

 

Do’h!