1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Getting a P0ADC-226 | c1310 | c1259 After installing new battery

Discussion in 'Gen 2 Prius Care, Maintenance and Troubleshooting' started by Mavi, Oct 20, 2018.

Page 2 of 2
  1. Mavi

    Mavi Active Member

    Joined:
    Oct 12, 2015
    484
    285
    0
    Location:
    San Diego,ca
    Vehicle:
    2020 Prius Prime
    Model:
    XLE
    Is going overtorque a bad thing or neutral at best as long as nothing is broken? I'm fairly sure I went over rather than under, but will check with my new 1/4" torque wrench later today.
     
    #21 Mavi, Nov 3, 2018
  2. Raytheeagle

    Raytheeagle Senior Member

    Joined:
    Jul 1, 2016
    11,257
    15,491
    0
    Location:
    Bay Area, California
    Vehicle:
    2019 Prius Prime
    Model:
    Prime Plus
    Over torque can be just as bad. While you may not see any damage initially, the extra force on the connection can lead to it being stripped over time as the fastener is under stress.
     
    #22 Raytheeagle, Nov 3, 2018
    05PreeUs likes this.
  3. 05PreeUs

    05PreeUs Senior Member

    Joined:
    Oct 1, 2016
    1,097
    563
    0
    Location:
    MSP
    Vehicle:
    2005 Prius
    Model:
    N/A
    It's WORSE, because once the fastener breaks, you cannot "back it off 1/2 turn and run it".... LOL :whistle::p
     
    #23 05PreeUs, Nov 3, 2018
  4. 05PreeUs

    05PreeUs Senior Member

    Joined:
    Oct 1, 2016
    1,097
    563
    0
    Location:
    MSP
    Vehicle:
    2005 Prius
    Model:
    N/A
    This matches up well with the "squeeling" sound the OP reported, sounds (no pun) like one of the HV relays is rapidly cycling. Were the relay nuts TORQUED? If not, you may have done internal damage to the #2 relay.
     
    #24 05PreeUs, Nov 3, 2018
  5. Mavi

    Mavi Active Member

    Joined:
    Oct 12, 2015
    484
    285
    0
    Location:
    San Diego,ca
    Vehicle:
    2020 Prius Prime
    Model:
    XLE

    Nah that code is now fixed.. that was due to a half connected connector. It makes no odd noises after fully seating the connector.. my only problem now is the internal resistance levels of the modules.
     
    #25 Mavi, Nov 3, 2018
    05PreeUs likes this.
(You must log in or sign up to post here.)
Page 2 of 2