1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Windsheild Wiper Replacements

Discussion in 'Gen 2 Prius Accessories & Modifications' started by JamesT, Sep 18, 2016.

  1. JamesT

    JamesT Junior Member

    Joined:
    Jul 28, 2014
    16
    0
    0
    Location:
    houston, tx
    Vehicle:
    2005 Prius
    Model:
    N/A
    Has anyone else had this issue? If I buy the recommended aftermarket wiper blades, the passenger side is too long and beats against the side of the window every stroke. It's very annoying, but I don't see anyone else complaining about it and apparently 18 inches is the correct size for the passenger side.
     

    Attached Files:

    #1 JamesT, Sep 18, 2016
  2. bisco

    bisco cookie crumbler

    Joined:
    May 11, 2005
    110,156
    50,059
    0
    Location:
    boston
    Vehicle:
    2012 Prius Plug-in
    Model:
    Plug-in Base
    is it longer than the oem? what did you buy?
     
    #2 bisco, Sep 18, 2016
    Mendel Leisk likes this.
  3. TerryM

    TerryM Member

    Joined:
    May 31, 2016
    46
    43
    0
    Location:
    West Central Illinois
    Vehicle:
    2021 Prius Prime
    Model:
    XLE
    Hard to tell from the angle of your picture, but is it possible the wiper arm has slipped a spline. On my '05 the passenger side wiper angles up just a little when in the off position. You may just need to remove and adjust the arm on the shaft.
     
    #3 TerryM, Sep 18, 2016
    garglo likes this.
  4. dolj

    dolj Senior Member

    Joined:
    May 14, 2012
    7,855
    3,968
    0
    Location:
    Wellington, New Zealand
    Vehicle:
    2007 Prius
    Model:
    N/A
    You realise that the passenger's side wiper is smaller than the driver's side. It looks like you have a driver's side fitted to the Passenger's side.
     
    #4 dolj, Sep 19, 2016
  5. 05PreeUs

    05PreeUs Senior Member

    Joined:
    Oct 1, 2016
    1,097
    563
    0
    Location:
    MSP
    Vehicle:
    2005 Prius
    Model:
    N/A
    Arm slipped on drive splines, easy fix!

    - Remove both wiper arms from their drive transmissions (normally a 12mm or 13mm bolt)
    - Turn car and wiper control to ON, allow wiper motor to run for a few cycles, turn wipers and car OFF
    - Reinstall wiper arms so that the blades are ~1" from the bottom of the windscreen; this should result in them being 90* to the centerline of the car +/-

    Enjoy.
     
    #5 05PreeUs, Oct 17, 2016
    Bluegrassman likes this.
(You must log in or sign up to post here.)