1. Attachments are working again! Check out this thread for more details and to report any other bugs.

ATF issue: Funnel Hose Length

Discussion in 'Prius c Care, Maintenance and Troubleshooting' started by SvMi, May 9, 2015.

  1. SvMi

    SvMi New Member

    Joined:
    Dec 27, 2014
    18
    1
    0
    Vehicle:
    2012 Prius c
    Model:
    Four
    Hi all,

    As I am trying to change my ATF, I ran into the error of my funnel-hose being too short (18 inches)
    I've been trying to look all over the place and cannot find a hose that's longer.. what is everyone else using ?

    Any suggestions or links to a longer hose that will fit as well ?

    Thanks !
     
  2. JC91006

    JC91006 Senior Member

    Joined:
    Nov 10, 2013
    16,525
    8,429
    0
    Location:
    Los Angeles, CA
    Vehicle:
    2008 Prius
    Model:
    II
    Home depot? Plumbing section has hoses of all sizes
     
    Mendel Leisk likes this.
  3. Mendel Leisk

    Mendel Leisk EGR Fanatic

    Joined:
    Oct 17, 2010
    56,695
    39,238
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    Checked the outside diameter on what I'm using, it's about 13.5 mm, slightly over 1/2". It fits in the fill hole with slight amount of clearance.
     
  4. SvMi

    SvMi New Member

    Joined:
    Dec 27, 2014
    18
    1
    0
    Vehicle:
    2012 Prius c
    Model:
    Four
    The plastic funnel/hose I have will be no good therefore..

    This should work: Hopkins TF-1

    As I have no experience with this, what do I have to buy to extend the hose ?

    I'm close to 50K and it has been bugging me to change the ATF..
    Thanks a lot !
     
  5. Mendel Leisk

    Mendel Leisk EGR Fanatic

    Joined:
    Oct 17, 2010
    56,695
    39,238
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    Capture.JPG

    ^ You could still use that funnel, just sub a longer tube section. Bring the whole thing along to Home Despot, to check fit?

    That's pretty much what I did, bought a similar funnel with screw-on extension, but not long enough.
     
  6. SvMi

    SvMi New Member

    Joined:
    Dec 27, 2014
    18
    1
    0
    Vehicle:
    2012 Prius c
    Model:
    Four
    [​IMG]
    This is what I have right now and when I remove the extension, there are grooves which looks proprietary to the hose..
     
  7. Mendel Leisk

    Mendel Leisk EGR Fanatic

    Joined:
    Oct 17, 2010
    56,695
    39,238
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    Yeah but this is just plastic. Get a clear tubing section with roughly the right inside diameter and you can screw it on ok.

    It's good to have an assistant pour, while you watch at the inlet. They can pour 3 quarts or liters without worries, then take it easy on the fourth. Somewhere around 1/2 to 3/4 through the fourth it should start coming back out.
     
  8. Yakoma

    Yakoma Active Member

    Joined:
    Oct 17, 2014
    470
    124
    0
    Location:
    ATL-ish
    Vehicle:
    2008 Prius
    Model:
    N/A
    Auto parts stores also sell rubber hose cut to length.
     
  9. xliderider

    xliderider Senior Member

    Joined:
    Apr 19, 2012
    7,921
    3,144
    0
    Location:
    Honolulu, HI
    Vehicle:
    2011 Prius
    Model:
    Three
    I bought 3 ft of 3/8 inch ID clear vinyl tubing from Lowe's or Home Depot. It's a little bit long, but better than too short.
     
    kerbear54 likes this.
  10. DKTVAV

    DKTVAV Active Member

    Joined:
    Jun 3, 2012
    510
    101
    0
    Vehicle:
    2012 Prius c
    Model:
    Four
    That's what she said. Sorry! Can't resist.


    BTW, thanks for this thread! I'm about to change the ATF oil too and didn't know I will need a long funnel to do the job.