What did you do to ur Gen III Prius today????

Buffed out scratches off my headlights.

 

I like the Snapple on the table, nice.

 

One was scuffed with small scratches and the other had deeper scratches. I was really surprised to get them as clear as I did.

 

Damn! Awesome I knew u could do it dude

 

I know this post is kind of old now, but what size are thos SSR GTV02s? I was thinking of either going 17 or 18. Can you post the size and the tires you're using? Thanks

 

They are 18x8.5 +44 with 225/40R-18 tires.

 

Awesome thanks! What kind of MPG are you getting?

 

Drove it off the dealer lot...

 

Now get home and start modding!!


PlusIV

 

I put my Blizzard Stashe Bear in my Prius.

 

New oil cap and JDM Engine covers today...... to be continued till next week wink wink

Before
After

 

Badassness has arrived in style!

It's not what I've done today..... but it's what I'm doing tonight when I get off.... Advan Carbon Fiber Duckwing

 

Where did you buy those engine covers? How much?

 

Wow!!!!

 

Crazy part is I got them in 3 days... I do not know how they did it but they did it haha

 

had the 70K miles service done last Saturday......

also had the front bearings checked... and driver side bearing was replaced (warranty).... was suppose to be done by Sat afternoon but the technician broke the tie rod... so had to wait for parts..... they gave a rental (prius plug in).... car was done Tue pm......

also I replaced my Tom's air filter (had it on the car for 40K miles) with this (HKS air filter)...

 

After experiencing all the peer pressure from all of you doing some nice mods , I had the itch to put coilovers I bought for the car back two months ago. Waited at the speed shop for about 2.5 hours for the job to be completed. Here is the result of conservative lowering:

Top hats installed.


The fronts appear to be slightly higher. Will need to do some minor adjustments this weekend!





Currently the settings are on the highest for this Tanabe setup - 1.1inch lowering rear, 0.75 inches lowering front. I would like to test the highest setting on the coilover vs. comfort and slowly move it down. For the final setting, I will also make the front 1cm lower for the raked look.

Unfortunately, I hit insane gridlocked traffic on the ride back home so could not test out the potential of new suspension mods. The ride appears to be slightly firmer. I will do a full detailed review of the Tanabe Sustec Pro-OC later.

 

Sweet man! The peer pressure does suck around here haha