2010 Toyota Prius model II Head Unit Upgrade

Thanks Kumatae. I wired it up today as saw what you're referring to.
It only blinked once and then went off. I reset it twice and tried to reconfigure it based on the instructions but it didn't work. I'll try again. Luckily, my client isn't too worried about the SWC working at the moment as he is loving the rest of the system upgrade.

Shell 8215 says thus.
Pin 6 - I grounded to the radio ground. I thought that this would be sufficient.
Pin 7 - Green/ orange from the ASWC
Pin 8 - Black/ Green from ASWC

 

Yeah that should have done the job. Hmmm... After I pressed the reset button, I didn't have to do any configuring, it just did everything on its own. The default configuration is most useful in my opinion. Getting the ASWC and mounting the deck properly with minial gaps was by far the hardest part about this install. I could probably tear apart the dash in less than 3min flat and have the radio out in 5min. Hope you get it to work!

 

I hope that's it. I'll give it a go when I get the car back for lowering. The kit that was provided was straight forward and very easy to install with no gaps. Yes, it's a 2min tearout to get the HU out

 

Hello,

I'm looking for a guide to remove the door trim to access the front speakers.

Thank you

 

Has anyone replaced the 2012 HU and retained all of the steering wheel controls? If so ...., well how do I do this?

I did a search and couldn't find a definitive answer.

 

Its the Canadian "Base" model, which near as I can tell is somewhat equivalent to a III.

It has the telephone controls in the steering wheel on the left side, a touch screen, no navigation.

 

I'm quite certain its the same HU as the US cars, touch screen, no navigation.

I'll start a new thread.

 

Thank you so much OP. I went and followed the instructions about upgrading the HU on a model II. I also have a Pioneer, but different model than the one in your instructions (so what?). Had to dremel the brackets to make the holes bigger, and a wee trial and error, got it to fit quit nicely.

Cheers!



I owed a pic of the end result.

I have noticed that the upper left corner seems to sink in a bit more than the right side. I have noticed this on anyone going with this trim. Except for this, I like this so much better than the regular aftermarket solutions.

 

hi need help my mini sd with GPS can't start download unit from china.

 

Does anyone have a copy of the documents from the OP? When I try to look at the docs via the links, the files are corrupted.

Thanks.

 

I had trouble uploading the pdf's, so here are some links to download them...
2010 Toyota Prius package II Head Unit Upgrade (v2.0).pdf
2010 Toyota Prius package II Head Unit Upgrade.pdf

 

Thanks for the PDF. My install went flawless with PAC SWI PS

 

I read your information on installing the dash speakers and had a couple questions.
1) Can you explain in dummy terms for me why additional bass blocking is necessary?
2) Doesn't the factory blocker block too wide a range of sounds from the speaker?
3) Do you know if any other 3.5" speakers fit as easily as the Pioneer ones?
4) Thanks for all the awesome detail in your post!!!!

 

There are a bunch of documents. Where are you reading about bass blocking?