1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Center floor side member extensions plugs?

Discussion in 'Prius c Main Forum' started by Oldwolf, Jun 19, 2012.

  1. Oldwolf

    Oldwolf Prius Enthusiast

    Joined:
    Feb 15, 2011
    820
    110
    0
    Location:
    NC
    Vehicle:
    2016 Prius v wagon
    Model:
    Four
    I found a plastic bag in glovebox that says in capital red letters: IMPORTANT

    Then below it says "To pre delivery inspector: Insert these rubber plugs into the holes of the center floor side member extensions."

    Where are the center floor side member extensions?
     
  2. ftl

    ftl Explicator

    Joined:
    Jun 2, 2009
    1,812
    790
    0
    Location:
    Long Island NY
    Vehicle:
    2012 Prius c
    Model:
    Three
    I found them there too; there's a thread here that describes where they go, and there should also be a diagram on the back of the bag.
     
  3. SquallLHeart

    SquallLHeart The Techie Guy

    Joined:
    Mar 10, 2012
    826
    247
    5
    Location:
    San Jose, CA
    Vehicle:
    2012 Prius c
    Model:
    Two
    yup.. it just pops in.. just poke your head under the car towards the back.
     
  4. Oldwolf

    Oldwolf Prius Enthusiast

    Joined:
    Feb 15, 2011
    820
    110
    0
    Location:
    NC
    Vehicle:
    2016 Prius v wagon
    Model:
    Four
    Mine does not have a diagram on the bag. Guess I will poke around the car tonight.
     
  5. ftl

    ftl Explicator

    Joined:
    Jun 2, 2009
    1,812
    790
    0
    Location:
    Long Island NY
    Vehicle:
    2012 Prius c
    Model:
    Three
    As Squall said, just pop your head under each side of the car and you'll see the holes about a foot forward of each rear wheel.
     
  6. Oldwolf

    Oldwolf Prius Enthusiast

    Joined:
    Feb 15, 2011
    820
    110
    0
    Location:
    NC
    Vehicle:
    2016 Prius v wagon
    Model:
    Four
    Will do, thanks.
     
  7. Oldwolf

    Oldwolf Prius Enthusiast

    Joined:
    Feb 15, 2011
    820
    110
    0
    Location:
    NC
    Vehicle:
    2016 Prius v wagon
    Model:
    Four
    So I installed the plugs tonight. The fitment didn't seem too water tight. I hope these plugs don't leak and keep water in instead of out.:cautious:
     
  8. X HCH2

    X HCH2 Member

    Joined:
    May 5, 2012
    119
    38
    0
    Location:
    Upstate SC
    Vehicle:
    2012 Prius c
    Model:
    Two
    I put gasket sealer on mine just to be sure they sealed off good.
    JD
     
  9. Oldwolf

    Oldwolf Prius Enthusiast

    Joined:
    Feb 15, 2011
    820
    110
    0
    Location:
    NC
    Vehicle:
    2016 Prius v wagon
    Model:
    Four
    I thought about that myself xhch2. I might use some RTV on them.
     
  10. Mike500

    Mike500 Senior Member

    Joined:
    Mar 1, 2012
    2,593
    764
    0
    Vehicle:
    2012 Prius v wagon
    Model:
    Two
    I've found these pulugs to be in two varieties.

    The ones that came with my Prius "v" were made in China and were quite thicker and stiffer.

    The ones made in USA were thinner and fit looser.
     
  11. donny612

    donny612 "Captain Jack Sparrow"

    Joined:
    Apr 12, 2012
    117
    13
    0
    Location:
    Apex, NC
    Vehicle:
    2012 Prius c
    Model:
    Two
    Now why do you suppose the dealer, or the port didn't install them??? That would be the question...
     
  12. X HCH2

    X HCH2 Member

    Joined:
    May 5, 2012
    119
    38
    0
    Location:
    Upstate SC
    Vehicle:
    2012 Prius c
    Model:
    Two
    The plugs from my Civic fit the Prius perfectly.
     
  13. Rainman16

    Rainman16 New Member

    Joined:
    Aug 24, 2015
    2
    0
    0
    Location:
    willis tx
    Vehicle:
    2015 Prius v wagon
    Model:
    V
     
  14. Rainman16

    Rainman16 New Member

    Joined:
    Aug 24, 2015
    2
    0
    0
    Location:
    willis tx
    Vehicle:
    2015 Prius v wagon
    Model:
    V
    I purchased a 2015 V and it still has the plugs in the glove box. I got on line to find out where they go. After finding out and finding the hole I placed my LED light into the hole and light shine all over! A lot of holes and slits so it does not seal anything! Maybe we are missing the right holes? I will ask techs on my 10K oil change.
     
  15. CoolPrius

    CoolPrius Active Member

    Joined:
    Apr 13, 2016
    218
    290
    86
    Location:
    Virginia
    Vehicle:
    2018 Prius c
    Model:
    Two
    Here is a picture of mine, they were also in the glove box. I spent a couple minutes looking up front but thanks to the thread it was an easy fix.
     

    Attached Files:

  16. Mendel Leisk

    Mendel Leisk EGR Fanatic

    Joined:
    Oct 17, 2010
    56,693
    39,238
    80
    Location:
    Greater Vancouver, British Columbia, Canada
    Vehicle:
    2010 Prius
    Model:
    Touring
    Pre-Delivery Inspection isn't what it used to be. There's a raft of things the dealership is supposed to do; sadly they tend to "mail it in", consider the PDI their "tip".

    Better double-check all the tire pressures too, including the temp spare. And fluid levels, etcetera.

    Email the service manager, you might get some freebies.
     
  17. JimBobWay

    JimBobWay Junior Member

    Joined:
    Jun 18, 2013
    7
    1
    0
    Vehicle:
    2021 Prius
    Model:
    XLE AWD-e
    Thank you for the photos and help from all. I just picked up a 2021 XLE-AWDe and the same plugs are still in the same place... THE GLOVE BOX.
     
  18. Dan Y

    Dan Y Junior Member

    Joined:
    Aug 21, 2021
    52
    10
    0
    Location:
    Brooklyn, NY
    Vehicle:
    2022 Prius
    Model:
    LE AWD-e
    And my wife and I just bought a new 2022 LE-AWDe and the same things in the glove box and Googling led me here. I'm wondering, what do these plugs even protect?