1. Attachments are working again! Check out this thread for more details and to report any other bugs.

service required light

Discussion in 'Gen 2 Prius Technical Discussion' started by red106, Jul 6, 2011.

  1. red106

    red106 New Member

    Joined:
    Jun 3, 2008
    4
    0
    0
    Location:
    golden,colorado
    Vehicle:
    2006 Prius
    does anyone know how to turn off the light that says maintenance required? is there a thread on that?
     
  2. jdenenberg

    jdenenberg EE Professor

    Joined:
    Nov 21, 2005
    3,872
    1,871
    1
    Location:
    Trumbull, CT
    Vehicle:
    2020 Prius
    Model:
    LE AWD-e
    It is in the users manual (but difficult to find).
    1 - Make sure that the main odometer reading is showing on the MultiFunctionalDisplay (MFD)
    2 - Turn the Prius off
    3 - Hold down the ODO button below the MFD, press the Brake and Power to turn on the Prius
    4 - Continue to hold the ODO button during the count down until the ODO goes back to its normal reading.
    5 - You have reset the Oil reminder message

    JeffD
     
  3. red106

    red106 New Member

    Joined:
    Jun 3, 2008
    4
    0
    0
    Location:
    golden,colorado
    Vehicle:
    2006 Prius
    thanks will try that.
     
  4. jdtechtalk00

    jdtechtalk00 New Member

    Joined:
    Jun 27, 2011
    19
    4
    0
    Location:
    New York City, NY
    Vehicle:
    2007 Prius
    Model:
    N/A
    Hello,

    Don't you just despise that judgemental little light glaring into the very pit of your soul? :p This is what I did to shut that irksome light off:

    1. Begin with power off.

    2. Press the "Power" Button while pressing down the brake petal, (Prius goes to "Ready" mode.

    3. Press the "ODO/Trip" button and select "ODO"on the display.

    4. Press the "POWER" button to turn the car off.

    5. Press and Hold the brake petal with your foot.

    6. Press and hold the "ODO/TRIP" button. Press the "POWER" button., (Prius goes to "Ready" mode.

    7. Continue to hold the "ODO/TRIP" button, with in a few seconds the "ODO" display on the dash will flash "------" and then for 1 second the display will read "000000" then,the Maintenance Reminder Light will go out and the "ODO" now displays your correct odometer mileage.

    8. Release the "ODO/TRIP" button.

    9. The Maintenance Light is now Reset (off).

    This is essentially the same procedure as described above but with the addition of superfluous details ;)