1. Attachments are working again! Check out this thread for more details and to report any other bugs.

Pro Bond

Discussion in 'Gen 3 Prius Accessories and Modifications' started by GaryD1, Mar 3, 2011.

  1. GaryD1

    GaryD1 Active Member

    Joined:
    Feb 7, 2011
    302
    138
    0
    Location:
    Seagrove, NC
    Vehicle:
    2016 Prius
    Model:
    Two
    I think I will try to put body side molding on myself. I have a wide roll of green body tape. I have a question about how to use tube of pro bond that came with molding. It reads to squeeze in center. I'm guessing the foam end becomes wet and it just smears on under tape line.

    Do you have to maintain pressure on the pro bond center as you put it on or how to use it?
     
    #1 GaryD1, Mar 3, 2011
  2. macmaster05

    macmaster05 Senor Member

    Joined:
    Sep 27, 2009
    4,050
    730
    5
    Location:
    USA
    Vehicle:
    2010 Prius
    Model:
    Two
    I have no idea how to use Probond. I would just go to the store and buy some 3M auto tape.
     
    #2 macmaster05, Mar 3, 2011
  3. firepa63

    firepa63 Former Prius Owner

    Joined:
    Jul 23, 2005
    1,761
    208
    0
    Vehicle:
    Other Hybrid
    Model:
    N/A
    I recommend putting the molding on the car. :doh:
     
    #3 firepa63, Mar 3, 2011
  4. GaryD1

    GaryD1 Active Member

    Joined:
    Feb 7, 2011
    302
    138
    0
    Location:
    Seagrove, NC
    Vehicle:
    2016 Prius
    Model:
    Two
    I will put it on myself. There is already adhesive on the molding. I may or may not use the pro bond glue that came with body side molding, I think I will wait till a nice warm up though, say 75 degree or so.
     
    #4 GaryD1, Mar 3, 2011
  5. danvee

    danvee Blizzard Brigadier

    Joined:
    Jun 30, 2010
    326
    53
    38
    Location:
    New Jersey
    Vehicle:
    2010 Prius
    Model:
    III
    The Pro Bond appears to be an adhesion promoter or primer. Without it you'll not get as good or durable a bond.
     
    #5 danvee, Mar 3, 2011
(You must log in or sign up to post here.)