1. Attachments are working again! Check out this thread for more details and to report any other bugs.

my yellow metal ramps don't work on my prius???

Discussion in 'Gen 2 Prius Main Forum' started by ski.dive, Oct 11, 2010.

  1. ski.dive

    ski.dive Active Member

    Joined:
    Jun 11, 2008
    929
    238
    0
    Location:
    Hutchinson Island,FL. Mt. Snow,VT
    Vehicle:
    2008 Prius
    I tried to use my yellow metal ramps to raise my prius, but the bottom of the front bumper would hit.
    what can i do to modify it so the bottom of the car will not hit?
     
  2. 2k1Toaster

    2k1Toaster Brand New Prius Batteries

    Joined:
    Feb 14, 2010
    6,035
    3,855
    0
    Location:
    Rocky Mountains
    Vehicle:
    2006 Prius
    Model:
    Three
    Yellow metal ramps? I am guessing something like:

    ------\\
    ______\\

    that you drive onto? If so, then get ramps with a longer angled section so the height variance isn't as great.
     
  3. Jon the Chief

    Jon the Chief Jon the Chief

    Joined:
    Oct 13, 2007
    50
    5
    0
    Location:
    Wolverhampton UK
    Vehicle:
    2008 Prius
    Keep the same ramps, just use a pair of wood planks to extend them and give a shallow angle
     
  4. philobeddoe

    philobeddoe ΜΟΛΩΝ ΛΑΒΕ

    Joined:
    Apr 23, 2008
    575
    107
    3
    Location:
    Los Angeles
    Vehicle:
    2008 Prius
    Model:
    N/A
    +1, decrease the angle of rise,
    planks, or shim the front, or go to pep boys and by some cheap shallower ramps ... mine work for my Prius and my truck, but truth be told, it's no easy feat getting a floor jack under the Prius either
     
  5. krg03

    krg03 Not expert, just experienced

    Joined:
    Jul 27, 2010
    246
    31
    0
    Location:
    so cal
    Vehicle:
    2007 Prius
    Model:
    II
    Mine aren't yellow but the same concept. I put 2x4 pieces in front of the ramp and it's just enough to raise it up and miss the bumper. Drive the car onto the 2x4 which raises the car up then onto the ramp. I had to do this with my mustang also. BTW, same concept - you can't rent a tow dolly from any rental place because the prius is too low to put on the dolly.
     
  6. fgoodyear

    fgoodyear New Member

    Joined:
    Aug 28, 2007
    187
    11
    0
    Location:
    Tillson, New York
    Vehicle:
    2007 Prius
    My floor jack works just fine, no problem at all, unless you have a huge commercial one. I use it every 5000 to rotate my tires. The ramp, however is a pain....



     
  7. ursle

    ursle Gas miser

    Joined:
    Jun 28, 2006
    1,049
    192
    0
    Location:
    NH
    Vehicle:
    2011 Prius
    Model:
    Four
    My yellow metal ramps came with plastic pieces that snap into position to walk the car up the ramps gradually, if using wood secure the wood in place, it would get ugly fast if they slipped and the vehicle err, gomered.
     
  8. ski.dive

    ski.dive Active Member

    Joined:
    Jun 11, 2008
    929
    238
    0
    Location:
    Hutchinson Island,FL. Mt. Snow,VT
    Vehicle:
    2008 Prius
    question:
    the 2x4 goes on the low side of the ramp, correct?
     
  9. wick1ert

    wick1ert Senior Member

    Joined:
    Dec 3, 2009
    1,311
    183
    2
    Location:
    Delawhere
    Vehicle:
    2010 Prius
    Model:
    III
    Put them in front of the ramps, up against it. I used a 2x6 and a 2x4 just to make sure I had enough room to get the tires on the wood before the bumper hit the ramps. I have the smaller Rhino ramps, also.

    It works great for oil changes, just enough clearance to open the splash guard cover and have the ground keep it open and not flopping around.
     
  10. ski.dive

    ski.dive Active Member

    Joined:
    Jun 11, 2008
    929
    238
    0
    Location:
    Hutchinson Island,FL. Mt. Snow,VT
    Vehicle:
    2008 Prius
    ***so the 2x4 goes in front of the ramp, not under the front of the ramp, correct?
     
  11. wick1ert

    wick1ert Senior Member

    Joined:
    Dec 3, 2009
    1,311
    183
    2
    Location:
    Delawhere
    Vehicle:
    2010 Prius
    Model:
    III
    Correct.

    If 1 - 2x4 doesn't turn out to be enough, put another one in front of the first.
     
  12. donalmilligan089

    Joined:
    May 16, 2008
    239
    22
    0
    Location:
    virginia usa
    Vehicle:
    2006 Prius
    I had the problem with u-haul dollies. They were not too high but not wide enough. I FOUND AN OLD MODEL (81 INCHES ) between fenders. It has a 2 foot ramp that lowers to load and raises to haul. Many have offered to buy it but I rent it and keep it for my friends. I believe the black plastic ranps at Advance Auto would do better Don
     
    1 person likes this.