What is the Trick to Removing Headlight Bulb Cover?

When I took mine off I turned it to the left (if I can remember correctly). I don't remember it being too hard to get off though..good luck

 

Turn it anticlockwise an inch or two. Just grab it with your hand and twist.

 

When I replaced the hid lamps on my 07, I found it necessary to a) wear a very sticky pair of gloves [some brands of nitrile or nitrile coated gloves work well], and b) only move it a small amount at first -- then move it back -- repeat as necessary. At least in mine, there apparently was some lube still present along the o-ring, and 'rocking' it back and forth helped distribute it -- after three or so short moves back and forth, it turned quite easily.

 

Do a search on this forum for 'HID Headlight' and you will see videos and instructions to remove the headlight assembly. Just be aware, some people have performed this operation w/o removing the bumper. However, there are other connectors under the cover that require room to maneuver. That's why the dealers recommend removing the bumper and the headlight assembly. Marvinh

 

Take a large flat screwdriver or pry bar and push against the fin. DO NOT tap on it, just apply pressure and push. It should start to move. When it does, it should move easily. You have to break the rubber seal loose.

 

I think you'll find a pair of sticky gloves [as previously noted] a little cheaper.